Abstract:Split tube furnaces, which rely on insulation commonly made of refractory ceramic fiber (RCF) material, are routinely used in nanotechnology laboratories to generate carbon-based nanomaterials and other manmade materials through chemical vapor deposition (CVD) processes. RCF aerosols can pose a use-phase inhalation risk to operators. We quantified the inhalation exposure risk and designed, built, and tested the impact of a benchtop ventilated enclosure for a common split tube furnace. Direct real-time measurements revealed that traditional use of the furnace could result in peak RCF total and respirable fraction particle mean concentrations of 25 ± 10 mg m −3 and 11 ± 4 mg m −3 , respectively ( n = 50). Employment of the ventilated enclosure reduces instantaneous exposure to total RCF dust and the respirable fraction to approximately baseline values: 0.006 mg m −3 ± 0.003 mg m −3 , and 0.003 mg m −3 ± 0.002 mg m −3 , respectively ( n = 30). The peak concentration of suspended particulate matter is highly variable over uniform release triggers, ranging from 5–50 mg m −3 for PM TOTAL and 2–18 mg m −3 for PM RESPIRABLE . Electron microscopic examinations of collected airborne materials were conducted to count the airborne number concentrations of RCFs greater than 5 μm in length, less than 3 μm in width, and that met a 5 : 1 length : width aspect ratio minimum, which are of toxicological concern. Concentrations of those RCFs were similarly reduced when the enclosure was in place. Technical drawings and specifications of the split tube furnace enclosure design are available for ready recreation and implementation, in light industry or laboratory settings, thereby providing low-cost modification to protect the health of workers and researchers.

A novel method for experiments in a one-atmosphere box furnace

A Nearly Zero Temperature Gradient Furnace System for High Pressure Multi-Anvil Experiments

Small furnace for the small angle X-ray scattering (SAXS) and wide angle X-ray scattering (WAXS) characterization of the high temperature carbonization of coal

A Rapid-Quench Technique for Multi-Anvil High-Pressure-temperature Experiments.

A New Hybrid Heating Method Used in Fire Test

Development of a microfurnace dedicated to in situ scanning electron microscope observation up to 1300 °C. II. Study of the thermal response of samples

A Furnace to 1200 K for in Situ Heating X-Ray Diffraction, Small Angle X-Ray Scattering, and X-Ray Absorption Fine Structure Experiments

A Portable Miniature Cryogenic Environment for in Situ Neutron Diffraction

Furnace for Inelastic X-Ray Scattering from Liquids to 1600C

Particles in a box: novel design and evaluation of an adaptable engineering control enclosure for a common split tube furnace to eliminate occupational exposure to refractory ceramic insulation fibers

A small sealed Ta crucible for thermal analysis of volatile metallic samples

Isothermal furnace for long-term in situ and real-time X-radiography solidification experiments

High-temperature furnace for in situ GISAXS studies

The Tube Furnace with Online Mass Loss Measurement as a New Bench Scale Test for Pyrolysis

The RAPTR furnace: a rapid heating and cooling sample furnace for in situ X‐ray scattering studies of temperature‐induced reactions

In-situ detection of nucleation in high temperature solutions

A Device with a Controllable Internal Atmosphere, Independent from the Heating Furnace, for Sintering Metal Particles

A novel rapid cooling assembly design in a high-pressure cubic press apparatus

A simple atomic beam oven with a metal thermal break

Flux-free fusion technique using a boron nitride vessel and rapid acid digestion for determination of trace elements by ICP-MS

Apparatus for studies of high-temperature chemical reactions in single particle systems