Abstract:Thermoelectric generator which converts waste heat to electricity is a promising approach in energy field. In this paper, a comprehensive numerical model of a thermoelectric couple is built by COMSOL with all related thermoelectric effects and some irreversible effects considered. It is adopted instead of a whole thermoelectric module modeling for a less calculation demanding and time consumption purpose, whose feasibility and equivalence are verified as well. An easy-manipulative symmetric test rig is designed to precisely acquire the electrical and thermal variables of thermoelectric module in terms of heat flow rate, voltage and current in a wide temperature range. The good agreement of test and simulation results validate the effectiveness of the numerical model and the feasibility of test device including its control and measurement systems. Then a novel characterization method called quasi-steady-state method is first proposed to fast and precisely derive the module-level temperature-dependent thermoelectric parameters including Seebeck coefficient S, thermal conductivity lambda and electrical resistivity rho. The characterization procedure is to raise the temperature of the thermoelectric modules hot side at an appropriate heating rate and keep the chiller at a constant temperature both in open and short circuit tests in sequence. The thermoelectric leg is regarded as multiple serial segments divided according to its temperature distribution. One set of equations involving the thermo- and electro- variables is established for each segment in case of a certain temperature difference. All these equations are solved by means of an iterative algorithm and computed by MATLAB. S and lambda are obtained by open circuit tests and rho by the short circuit tests subsequently. The comparison of estimated thermoelectric parameters by tests, simulations and the manufacturers data validate the correctness of the quasi-steady-state method and its predictability ability of the performance of thermoelectric generators in practice.

Calculation model of thermoelectric system for cooling discrete semiconductor devices

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Efficient Thermoelectric Cooler for Localized Cooling in Electronic Devices

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Assessment and validation of a numerical model for phase change materials heatsink on thermoelectric devices

Designing thermoelectric self-cooling system for electronic devices: Experimental investigation and model validation

Performance enhancement of a novel thermoelectric self-cooling system for electronic devices

Design and Optimization of Thermoelectric Cooling System under Natural Convection Condition

Performance Research of a Semiconductor Cooling Device with Solid Desiccant

An Approximate and Efficient Characterization Method for Temperature-Dependent Parameters of Thermoelectric Modules

Irreversibility of thermoelectric cooling model: Newtonian linear heat transfer and finite time thermodynamics

Thermal Resistance Matching for Thermoelectric Cooling Systems

Numerical investigation of heat transfer mechanism in an embedded PCM-TEG for better overall performance under the fluctuating heat source

Enhancing the Maximum Coefficient of Performance of Thermoelectric Cooling Modules Using Internally Cascaded Thermoelectric Couples.

Thermodynamic Analysis of TEG-TEC Device Including Influence of Thomson Effect

Contribution of the distributed Peltier effect to the efficiency of the thermoelectric cooler branch

Simulation of the cold-end temperature and the optimal current of thermoelectric cooler with variable semiconductor cross section using lattice boltzmann method

Improvement of Thermal Environment by Thermoelectric Coolers and Numerical Optimization of Thermal Performance

Modelling and analysis of a liquid-cooled system for thermal management application of an electronic equipment

Numerical Study and Optimization of a Combined Thermoelectric Assisted Indirect Evaporative Cooling System