Abstract:Thermoelectric generator (TEG) with improved performance is a promising technology in power supply and energy harvesting. Existing studies primarily adopt constant material properties to investigate TEG performance. However, thermoelectric (TE) material properties are subjected to considerable variations with temperature. Thus, reasonable doubts have risen concerning the influence level of temperature-dependent material properties on TEG performance. To solve this problem, an efficient and a comprehensive one-dimensional numerical model is developed to fully consider the third-order polynomial temperature-dependent thermal conductivity, Seebeck coefficient, and electrical resistivity. Control volume and finite difference algorithms are compared, and experiments are conducted to verify the developed numerical model. The temperature distribution along the TE leg obviously differs from the parabolic shape, which is a classic temperature distribution under the assumption of constant material properties. Insights find that the local change rate of thermal conductivity and Thomson effect are the essential reasons for the abovementioned phenomenon. It has been found that Thomson heat is released in the part of the leg near the cold-end, whereas it is absorbed in the remaining parts of the leg near the hot-end. The electric power on the basis of constant material properties is confirmed to be accurate enough by the developed numerical model, but the parabolic shape of the TE efficiency can be only obtained when temperature-dependent material properties are considered. Furthermore, it is wise to improve the TE efficiency by structural optimization. The present work provides an efficient and a comprehensive one-dimensional numerical model to include temperature-dependent material properties. New insights into the temperature and heat flux distribution, Thomson influence, and structural optimization potential are also presented for the in-depth understanding of the TE conversion process.

Numerical Examination of the Performance of a Thermoelectric Cooler with Peltier Heating and Cooling

Numerical Simulation On Ionic Wind Heat Transfer In A Thermoelectric Cooling Sysytem

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Numerical Study and Optimization of a Combined Thermoelectric Assisted Indirect Evaporative Cooling System

Numerical analysis of thermoelectric power generation coupled with temperature-dependent material properties

Thermoelectric Performance Evaluation and Optimization in a Concentric Annular Thermoelectric Generator under Different Cooling Methods

Efficient Thermoelectric Cooler for Localized Cooling in Electronic Devices

Numerical Simulations on the Temperature Gradient and Thermal Stress of a Thermoelectric Power Generator

Computational study of pulse current and thermal stress on thermoelectric cooler

Performance Evaluation and Optimization of Air-to-Air Thermoelectric Heat Pump System

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Analysis and Verification of Seebeck Effect and Peltier Effect Co-existence on a Thermoelectric Device

Maximization of the thermoelectric cooling of graded Peltier by analytical heat equation resolution

Design and Optimization of Thermoelectric Cooling System under Natural Convection Condition

Test for Thermoelectric Self Cooling

Performance enhancement of a novel thermoelectric self-cooling system for electronic devices

The Elusive Thomson Effect in Thermoelectric Devices. Experimental Investigation from 363 K to 213 K on Various Peltier Modules

Parametric Study of Thermoelectric Power Generators under Large Temperature Difference Conditions

The influence of Peltier effect on the exergy of thermoelectric cooler‐thermoelectric generator system and performance improvement of system