Abstract:In vertical-up laser mirror welding, the keyhole dynamics and flow behavior of molten pool play crucial roles in weld quality, yet the mechanisms of these coupling dynamics have not been well clarified. In this work, a three-dimensional transient model for simulation of vertical-up laser mirror welding process was carried out to account for the flow behavior of molten pool and dynamic evolution characteristics of keyhole. Two laser heat sources with regard to laser mirror welding were also taken into consideration in the combined heat source model. It is proved that the simulation results are basically consistent with the experimental data. The simulation results indicate that the morphology and flow field distribution of upper and lower molten pool both exhibit a high degree of consistency on the X–Y section, while significant difference is visible on the X-Z section. Before keyhole coupling, the high velocity fluid exists on the surface of molten pool and tends to increase the diameter of keyhole, of which the maximum velocity reaches 5.26 m s −1 . During the keyhole coupling process, the coupled keyhole in the center area is found to fall, which results in deteriorated coupling process. Force analysis of keyhole illustrates that the resultant force on the X–Y section points to the direction of increasing the depth and diameter of keyhole before and during the keyhole coupling process. In contrast, the resultant force on the X-Z section is conductive to keyhole coupling occurring at the lower position. After keyhole coupling, the diameter of coupled keyhole in the center zone is increased and the fluid velocity is reduced to 0.109 m s −1 , contributing to a firm connection.

Porosity morphology and its evolution mechanism in laser mirror welding of 2219 aluminum alloy

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

The tensile properties of 2219 aluminum alloy plate butt joint welded by novel laser mirror welding

Numerical analysis of coupling dynamics of keyhole and molten pool in vertical-up laser mirror welding of 2219 aluminum alloy

Research on keyhole-induced porosity and melt flow kinetic behavior of 2219 alloy T-joint manufactured by dual laser-beam bilateral synchronous welding

Investigation of the Inhibition Mechanism of Process Porosity in Laser-MIG Hybrid-Welded Joints for an Aluminum Alloy

Numerical simulation of gravity effects on keyhole behaviors in laser mirror welding of 2219 aluminum alloy

Mitigation of porosity in adjustable-ring-mode laser welding of medium-thick aluminum alloy

Numerical simulation on pore formation and suppression for dual-beam laser welding of sandwich structure

Study on the influence of Al-Si welding wire on porosity sensitivity in laser welding and process optimization

Modeling and numerical study of keyhole-induced porosity formation in laser beam oscillating welding of 5A06 aluminum alloy

Numerical study of keyhole dynamics and porosity formation during high‐power oscillating laser welding of medium‐thick aluminum alloy plates

Thermal and Fluid Flow Characteristics and their Relationships with Porosity in Laser Welding of AA5083

Microstructural Inhomogeneity in the Fusion Zone of Laser Welds

Investigation on the keyhole/molten pool dynamic behavior during adjustable ring-mode laser welding of medium-thick aluminum alloy

Effect of Porosity Morphology and Elements Characteristics on Mechanical Property in T-joints During Dual Laser-Beam Bilateral Synchronous Welding of 2060/2099 Al-Li Alloys

Behavior of melt flow and porosity formation in laser welding of steel to aluminum with cold-sprayed steel interlayer

Porosity inhibition of aluminum alloy by power-modulated laser welding and mechanism analysis

Investigation on Porosity Suppression in Deep-Penetration Laser Welding by Using Computational Fluid Dynamics

Formation Regularity of Pores During Laser Welding of Die-Cast Magnesium Alloys and Its Mechanism

Simulation of the Effect of Keyhole Instability on Porosity during the Deep Penetration Laser Welding Process