Abstract:The purpose of the current study was to implement unequal microstrip power splitters for parallel transmission at 7 T that are optimized for size and loss and that can be configured for a wide range of power ratios. The splitters will enable the use of more transmit coils without a corresponding increase in the number of transmit channels or amplifiers to control specific absorption rate, shorten RF pulses, and shim inhomogeneous RF fields. Wilkinson unequal power splitters based on a novel microstrip network design were optimized to minimize their size under 8 cm in length and 9 cm in width, enabling them to be included in coil housing or cascaded in multiple stages. Splitters were designed and constructed for a wide range of output power ratios at 298 MHz. Simulations and bench tests were performed for each ratio, and a methodology was established to adapt the designs to other ratios and frequencies. The designs and code are open source and can be reproduced as is or reconfigured. The single-stage designs achieved good matches and isolations between output ports (worst isolation -15.9 dB, worst match -15.1 dB). A two-stage cascaded (one input to four outputs) power splitter with 1:2.5, 1:10, 1:3, and 1:6 ratio outputs was constructed. The worst isolation between output ports was -19.7 dB in simulation and the worst match of the three ports was -17.8 dB. The measured ratios for one- and two-stage boards were within 10% of the theoretical ratios. The power-handling capability of the smallest trace was approximately 70 W. Power loss for the one- and two-stage boards ranged from 1% to 3% in simulation compared with 5.1% to 7.2% on the bench. It was concluded that Wilkinson unequal microstrip power splitters can be implemented with a small board size (low height) and low loss, and across a wide range of output power ratios. The splitters can be cascaded in multiple stages while maintaining the expected ratios and low loss. This will enable the construction of large fixed transmit array-compression matrices with low loss.

Design of a Compact Power Splitter With Improved Performance for Wireless Applications Using Recurrent and Feed Forward Neural Networks Inverted Models

A Fast Surrogate Model-Based Algorithm Using Multilayer Perceptron Neural Networks for Microwave Circuit Design

Inverse design of a novel multiport power divider based on hybrid neural network

Mid-Infrared, Ultra-Broadband, Low-Loss, Compact Arbitrary Power Splitter Based on Adiabatic Mode Evolution

Inverse design of high efficiency and large bandwidth power splitter for arbitrary power ratio based on deep residual network

A Novel Broadband Microstrip Power Divider Using Split-Ring Resonator

A Novel Reconfigurable Three-Way Power Divider Constructed on Unitary Plane

Novel Dual-Band Out-of-Phase Power Divider with High Power-Handling Capability

Design of a Compact Variable Waveguide RF Power Splitter for High-Power Applications

Design of a Variable X-band RF Power Splitter

DESIGN OF A COMPACT VARIABLE X-BAND RF POWER SPLITTER

Development of a Compact X-band Variable-Ratio RF Power Splitter

Design and Analysis of a Novel Broadband Tweaked T-shaped Stub-loaded Quadrature Power-Splitter

A Miniaturized Dual-Band Diplexer Design with High Port Isolation for UHF/SHF Applications Using a Neural Network Model

Digital-Based Inverse Design for Ultra-Compact Power Splitter on LNOI

Simulation and design of Ku-band Wilkinson power splitters

On the design and manufacturing of miniaturized microstripline power splitters for driving multicoil transmit arrays with arbitrary ratios at 7 T

A new design of compact microstrip Wilkinson power dividers

Design of a microstrip Wilkinson power divider using a low pass filter with the particle swarm optimization algorithm

Proposal and Design of a Power Divider with Wideband Power Division and Port-to-Port Isolation: A New Topology

Design of a Novel Plasmonic Splitter with Variable Transmissions and Selectable Channels