Abstract:In recent years, there has been growing interest for the identification of material constitutive equations using machining tests (inverse method). However, the inverse method has shown some drawbacks that could affect the accuracy of the identified material constants. On one hand, this approach requires the use of analytical model to estimate the cutting temperature. Nevertheless, the used temperature models lead to large discrepancies for the calculated temperatures even for the same work material and cutting conditions. On the other hand, some computation issues were observed when all material constants were determined, in the same time, using machining tests data. Therefore, this study attempts to provide a methodology for identifying the coefficients of the Marusich’s constitutive equation (MCE) which demonstrated a good capability for the simulation of the material behavior in high speed machining. The proposed approach, which is based on an analytical inverse method together with dynamic tests, was applied to aluminum alloys AA6061-T6 and AA7075-T651, and induction hardened AISI 4340 steel (60 HRC). The response surface methodology was used in this approach. Two sets of material coefficients, for each tested work material, were determined using two different temperature models (Oxley and Loewen-Shaw). The obtained constitutive equations were validated using dynamic tests and finite element simulation of high speed machining. The predictions obtained are also compared to those performed with the corresponding Johnson and Cook constitutive equations (JCE) from the literature. The sensitivity analysis revealed that the selected temperature models used in the analytical inverse method can affect significantly the identified material constants and thereafter predicted dynamic response and machining data. Moreover, the MCE obtained using the hybrid method performed better than the JCE obtained by only dynamic tests.

The Johnson Cook model for the machinability study

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models

A modified parallel-sided shear zone model for determining material constitutive law

Finite element simulations of Ti6Al4V titanium alloy machining to assess material model parameters of the Johnson-Cook constitutive equation

Experimental Development of Johnson–Cook Strength Model for Different Carbon Steel Grades and Application for Single‐Pass Hot Rolling

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

Parameter identification of Johnson-Cook constitutive model based on genetic algorithm and simulation analysis for 304 stainless steel

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Research on inverse identification of Johnson-Cook constitutive parameters for turning 304 stainless steel based on coupling simulation

An Hybrid Approach Based on Machining and Dynamic Tests Data for the Identification of Material Constitutive Equations

Study on constitutive relationship of 6061 aluminum alloy based on Johnson-Cook model

A modified Johnson-Cook model to determine plastic flow behavior of Fe-30Mn-9Al-0.8 C low-density steel during warm multiaxial forging

Modification of strain rate strengthening coefficient for Johnson-Cook constitutive model of Ti6Al4V alloy

Effects of Strain Hardening and Initial Yield Strength on Machining-Induced Residual Stresses

Experimental Determination and Simulation Validation: Johnson–Cook Model Parameters and Grinding Simulation of 06Cr18Ni11Ti Stainless Steel Welds

Calibration of the Johnson–Cook model at high temperatures for an Ultra-High Strength CrNiMoV Steel

Experiment and Numerical Simulation on Cross-Die Forming of SUS304 Metastable Austenitic Stainless Using a Modified Johnson-Cook Model

A Modified Johnson–Cook Constitutive Model for Characterizing the Hardening Behavior of Typical Magnesium Alloys under Tension at Different Strain Rates: Experiment and Simulation

Investigation into thermodynamic behavior of LA103Z Mg Li alloy during turning based on modified Johnson–Cook model

A Hybrid Cutting Force Model for High-speed Milling of Titanium Alloys