Abstract:The wide-width titanium strip cold rolling, as an efficient titanium material processing technology, has been widely concerned. During the cold rolling process, high-order flatness defects occur frequently, seriously restricting the improvement of titanium product quality. To analyze the mechanical deformation behavior of titanium strips during cold rolling, and explore the influence of entrance and exit profile index on the generation of high-order flatness defects. An integrated coupling rolling model of the roll system and the strip has been established based on the FEM method, and the accuracy of the model has been verified using on-site measured data. The research results show that when the taper or coning amount of the first intermediate roll increases, if the entrance profile index remains unchanged, the exit profile index will significantly decrease, and the high-order deflection deformation of the work roll axis will occur, ultimately leading to high-order flatness defects. When using the first intermediate taper roll to control the exit profile index, if the exit profile index remains unchanged, the entrance profile index increases by 10 μm, and the coning amount will increase by 8.3mm. Therefore, a plan based on the optimization of the entrance profile index has been proposed, which takes into account both the profile and the high-order flatness, to achieve a smaller coning amount to meet the exit profile index and decrease the risk of high-order flatness. The industrial test results show that after the implementation of the plan, the occurrence rate of high-order flatness decreased by an average of 34.42%.

Evaluation of the type and amplitude of the flatness defect of a hot-rolled steel strip produced on a continuous mill

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Analytical model of hot-rolled strip residual stress and flatness in run-out table cooling

Analysis of flatness and critical crown of hot-rolled strip based on thermal-mechanical coupled residual stress analytical model

New shapemeter roll technology based on Fiber Bragg Grating technology for on-line flatness monitoring of thin cold rolled metal sheets

Data Mining-Based Flatness Pattern Prediction for Cold Rolling Process with Varying Operating Condition

Residual stress control of hot-rolled strips during run-out table cooling

Digital simulation of aluminum alloy slab rolling with low relative reduction

Automated Visual Defect Detection for Flat Steel Surface: A Survey

STUDY OF THE APPLICATION OF INDIRECT METHODS OF ASSESSMENT OF CHANGES IN THE THICKNESS OF THE ROLLED CAGE AS A CONSEQUENCE OF THE INFLUENCE OF THE WEAR OF THE ROLLED CAGE EQUIPMENT

Research of Asymmetric and Symmetric Cold Rolling Influence on Microstructure, Mechanical Properties and Stress–Strain State of Steel Strips

Automated Visual Defect Classification for Flat Steel Surface: A Survey

Analysis and mathematical modeling for microgeometry reproduction of a textured roll surface on a cold-rolled galvanized strip during temper rolling

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

Effect of the Roller-Height-difference of Tensiometer Loopers on the Precision of Flatness Measurement

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

Measurements of Surface Roughness in Cold Metal Rolling in the Mixed Lubrication Regime

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Aspects of Continuous Rolling When Starting with Unreduced Strip