Fabrication of TiO2/MXene Nanohybrid Electron Transport Layer by Artist Spray Gun Assisted Pyrolysis Method for Efficient Carbon Perovskite Solar Cell

Pratheep Panneerselvam,Senthilkumar Ramasamy,Saradh Prasad Rajendra,Mohamad S. AlSalhi,JohnZhanhu Guo,Subramania Angaiah
DOI: https://doi.org/10.1002/admt.202201551
IF: 6.8
2023-03-02
Advanced Materials Technologies
Abstract:MXene is hybrid with nano TiO2 powder by ASG assisted pyrolysis method. MXene allows charges to flow easily between the nano TiO2 and generate a 3D linked structure in TiO2/MXene nanohybrid electron transport layer (ETL). The PSC fabricated by using TiO2/MXene nanohybrid ETL generates the PCE of 5.15% with an improvement of ≈12% to that of pristine TiO2 ETL. A new class of 2D Ti3C2Tx (MXene) in different weight percentages (0, 1, and 2 wt.%) are hybrid with TiO2 nanopowder to form TiO2/MXene nanohybrids by artist spray gun assisted (ASG) pyrolysis method to use an electron transport layer (ETL) for carbon perovskite solar cell (PSC). The influence of Ti3C2Tx on TiO2 in light absorption, charge separation and carrier dynamics is studied in detail. The formation of TiO2/MXene is studied by X‐ray diffraction analysis. The emission spectrum, charge separation and carrier dynamics of TiO2/MXene nanohybrid are analyzed by photoluminescence studies. They exhibited an emission spectrum at 390 nm. The photoluminescence and electrochemical impedance results reveal that the Ti3C2Tx nanosheets provide a superior charge transfer path with less electron transfer resistance at the ETL/perovskite interface, which lead to produce higher photocurrent. This study revealed that TiO2/MXene nanohybrid can be used as a promising ETL to enhance the photo‐conversion efficiency of carbon PSC. These results revealed that TiO2‐ MXene (1 wt.%) nanohybrid ETL shows the highest PCE of 5.15% than that of TiO2‐ MXene (2 wt.%) nanohybrid ETL and pristine TiO2 ETL‐based PSC (4.64%).
materials science, multidisciplinary
What problem does this paper attempt to address?