Abstract:In this work, a reliable and robust in situ non-matrix-matched calibration method is proposed for element composition determination in scheelite samples. With external calibration against the silicate glass standard reference material NIST SRM 610, the concentrations of both major elements (Ca and W) and trace elements (Si, Fe, Mo, Y, rare earth elements, etc.) in scheelite are determined using an ArF 193 nm excimer nanosecond laser ablation-inductively coupled plasma mass spectrometer (LA-ICP-MS). Here, the ablation was performed by hole drilling under a helium (He) environment using a laser spot size of 35 μm and a laser repetition of 5 Hz, and the aerosols were then transported to a quadrupole ICP-MS by a mixture of He and make-up gas argon (Ar) with a total gas flow rate of 1.6 L/min. Results showed that there was no apparent matrix effect between the NIST SRM 610 and scheelite by this proposed method. With internal standardization against W, the obtained concentrations of CaO and WO3 were found to yield an average matrix CaO/WO3 mass fraction ratio of 0.245 (2σ = 0.003, n = 19), which agreed well with the value of 0.243 (2σ = 0.002, n = 15) from electron probe microanalysis (EPMA). Furthermore, the accuracy of trace element analyses with this proposed non-matrix-matched calibration in situ method was evaluated by comparing the concentration results with those from bulk analysis by solution nebulizer ICP-MS (SN-ICP-MS). It was found that the quantification results from LA-ICP-MS and SN-ICP-MS were comparable, in particular showing a relative concentration bias of the total ∑REE+Y contents of less than 2%. This confirmed that scheelites can be accurately analyzed in situ by LA-ICP-MS without matrix-matched calibration standards. By using this developed in situ method, the element compositions in a series of scheelite samples from different W-associated deposits in China were successfully quantified, promising further genetic process investigation and associated geologic activities of the polymetallic resources.

Element analysis of limestone based on inelastic neutron scattering system

Elemental analysis of limestone by instrumental neutron activation analysis

Elemental analysis of limestone by laser-induced breakdown spectroscopy, scanning electron microscopy coupled with energy dispersive x-ray spectroscopy and electron probe microanalysis

Determination of Multi-Element in Limestone by ICP-OES with Microwave Digestion

Combined use of multiple external and internal standards in LA-ICP-MS analysis of bulk geological samples using lithium borate fused glass

LA-ICP-MS ANALYSIS OF TRACE ELEMENTS IN SILICATE MINERALS ON ICP-MS NEXION 300S MASS SPECTROMETER WITH NWR 213 ATTACHMENT FOR LASER ABLATION: METHODOLOGICAL ASPECTS

[Elemental Analysis of Rock with Remote Laser Induced Breakdown Spectroscopy].

A Non-Matrix-Matched Calibration Method for In Situ Major and Trace Element Analysis of Scheelite by Nanosecond LA-ICP-MS

Quantitative analysis of cement raw materials based on nanoparticle-enhanced laser-induced breakdown spectroscopy

Enhanced ICP-MS detection of 24 elemental impurities in complex, high matrix mineral, medicinal lanthanum carbonates according to ICH Q2 (R2)

Elemental analysis of concrete via fast neutron transmission and scattering spectrometry

High-Precision Measurement of Eu/Eu* in Geological Glasses Via La-Icp-Ms Analysis

Elemental Imaging Method Based on a Dielectric Barrier Discharge Probe Coupled with Inductively Coupled Plasma Mass Spectrometry

Determination of Trace Elemental Composition of CaCO3: Application to Mass Limited Abiogenic and Biogenic Carbonates

High spatial resolution quantitative elemental imaging of foraminifer by laser ablation-inductively coupled plasma-mass spectrometry

Light Element (C, N, O) Quantification by EDXS: Application to Meteorite Water Content and Organic Composition

Trace elements determination by femtosecond LA-ICP-MS of 10 mg extraterrestrial geological samples prepared as lithium borate glasses

In situ calcite U−Pb geochronology by high-sensitivity single-collector LA-SF-ICP-MS

Quantitative analysis of main components in ceramic raw materials based on the desktop LIBS analyzer

Quantitative Analysis of Mg, Fe and Ca in Jade with Laser Induced Breakdown Spectroscopy.

Parametric Study of Spot Size and Multi-Elemental Quantification of Geomaterials under Complex Matrix Conditions Using Fiber-Optic Laser-Induced Breakdown Spectroscopy