Abstract:The isotopic composition of sulfur is a vital tracer used in the Earth and planetary sciences. In this study, the laser-and ICP-induced isotopic fractionation in S-rich minerals (sulfides and elemental S) with different matrices was investigated by using 257 nm femtosecond (fs) and 193 nm ArF excimer nanosecond (ns) laser ablation systems coupled to a Neptune Plus MC-ICP-MS. Compared to ns-LA-MC-ICP-MS, higher sensitivity (1.4-2.4 times) under similar instrumental conditions and better precision (similar to 1.6-fold) under the same signal intensity condition were achieved by fs-LA-MC-ICP-MS. In addition, a fs-laser provides less fluence and matrix dependent S isotopic fractionation, and more stable transient isotopic ratios compared to a ns-laser. Better results acquired by fs-LA-MC-ICP-MS were attributed to the smaller size of particles and less thermal effect produced by using the fs-laser, which were evidenced by the morphologies of the ablation craters and ejected aerosol particles of P-S-1 (the pressed powder pellet of IAEA-S-1) and PPP-1 (a pyrite single crystal from the Sukhoi Log deposit). The ICP-induced isotopic fractionation (matrix effect) was still found in fs-LA-MC-ICP-MS under the maximum sensitivity conditions. However, a significant reduction of the matrix effect was obtained under robust plasma conditions at a lower makeup gas flow rate (0.52-0.54 l min(-1)) relative to the maximum sensitivity condition (0.6 l min(-1)) for S isotope analysis. This could be ascribed to the particles that not only pass into the higher temperature ICP for a longer residence time at a lower makeup gas flow rate that resulted in more efficient vaporization of the particles, but also experience a more robust plasma induced by adding 4-6 ml min(-1) N-2 into the plasma. Furthermore, under the robust conditions, the results of six reference materials with different matrices obtained by fs-LA-MC-ICP-MS with non-matrix matched calibration with a spot size of 20-44 mm showed excellent agreement with the reference values (the accuracy of 0.01-0.15 parts per thousand for delta S-34 and 0.11-0.45 parts per thousand for delta S-33 and the precision of 0.16-0.40 parts per thousand (2 s) for delta S-34 and 0.35-0.78 parts per thousand (2 s) for delta S-33) and the mass-dependent fractionation line, validating the applicability of the proposed approach for providing high-quality in situ isotope data (delta S-33 and delta S-34) of sulfides and elemental sulfur at high spatial resolution using non-matrix matched analysis.

High spatial resolution quantitative elemental imaging of foraminifer by laser ablation-inductively coupled plasma-mass spectrometry

2D geochemical imaging of biogenic marine carbonates using LA-TOF-ICP-MS at 1 and 2 μm pixel resolution

Improved in situ Sr isotopic analysis by a 257 nm femtosecond laser in combination with the addition of nitrogen for geological minerals

In Situ Analysis of Mg Isotopic Compositions of Basalt Glasses by Femtosecond Laser Ablation Multi-Collector Inductively Coupled Plasma Mass Spectrometry

In situ determination of trace elements in melt inclusions using laser ablation-inductively coupled plasma-sector field-mass spectrometry.

Assessing the Precision and Accuracy of Foraminifera Elemental Analysis at Low Ratios

Simultaneous measurement of major, trace elements and Pb isotopes in silicate glasses by laser ablation quadrupole and multi-collector inductively coupled plasma mass spectrometry

Quantitative Imaging Analysis and Investigation of Transmission Loss in PbF2 Crystals by Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry Method.

Quantitative analysis of trace element abundances in glasses and minerals: a comparison of laser ablation inductively coupled plasma mass spectrometry, solution inductively coupled plasma mass spectrometry, proton microprobe and electron microprobe data

Contrasting Matrix Induced Elemental Fractionation in NIST SRM and Rock Glasses During Laser Ablation ICP-MS Analysis at High Spatial Resolution

Simultaneous in Situ Determination of Pb Isotope Ratios and Trace Element Concentrations in Melt Inclusions by LASS‐ICP‐MS

High spatial resolution trace element determination of geological samples by laser ablation quadrupole plasma mass spectrometry: implications for glass analysis in volcanic products

Visualization of Critical Metals in Marine Nodules by Rapid and High-Resolution LA-ICP-TOFMS Mapping

In situ calcite U−Pb geochronology by high-sensitivity single-collector LA-SF-ICP-MS

Accurate determination of sulfur isotopes (delta S-33 and delta S-34) in sulfides and elemental sulfur by femtosecond laser ablation MC-ICP-MS with non-matrix matched calibration

Accurate determination of sulfur isotopes (δ33S and δ34S) in sulfides and elemental sulfur by femtosecond laser ablation MC-ICP-MS with non-matrix matched calibration

Fast and high spatially resolved multielemental mapping of otoliths using IR&UV-femtosecond laser ablation-ICP-TOFMS

Elemental Imaging Method Based on a Dielectric Barrier Discharge Probe Coupled with Inductively Coupled Plasma Mass Spectrometry

Quantitative Analysis of Trace Elements in Geological Materials by Laser Ablation Icpms: Instrumental Operating Conditions and Calibration Values of Nist Glasses

Simultaneous Determination of Trace Elements and Lead Isotopes in Fused Silicate Rock Powders Using a Boron Nitride Vessel and fsLA-(MC)-ICP-MS

A New Analytical Mode and Application of the Laser Ablation Inductively Coupled Plasma Mass Spectrometer in the Earth Sciences