Abstract:Understanding the initiating and suppression mechanisms of existing defects are the key to optimizing the ultra-precision grinding process of hard and brittle materials. This paper discusses the effects of grinding damage on material removal mechanism from the perspectives of residual scratch depth, scratch morphology and normal scratching force, through conducting the contrast variable-depth nano-scratch experiment on polished and ground monocrystalline silicon and establishing the single grain scratching Smoothed Particle Hydrodynamics (SPH) model. The experimental and simulation results show that radial crack on ground silicon surface is almost invisible due to the existence of grinding marks, which indicates that it is difficult to judge the ductile brittle transition (DBT) point by the traditional method of observing cracks. With the increase of penetration depth, pop-in will occur in the residual scratch depth of polished and ground silicon, indicating that the material removal mode has transformed, which provides an important basis for judging the DBT point. The DBT critical normal scratching force (38.93 mN) and residual scratch depth (−0.14 μm) of ground silicon are much higher than those of polished silicon, implying ground silicon is easier to achieve ductile processing. Meanwhile, when the penetration depth is the same, compared to polished silicon, the normal scratching force of ground silicon is generally larger. Finally, a single grain scratching SPH model of pre-stressed silicon is established. And the simulated phenomenon and conclusions are consistent with the experiment, which proves that the surface compressive stress is an important factor that causes the removal characteristics of ground silicon to be different from polished silicon. This study provides a theoretical basis for understanding the ultra-precision grinding removal mechanism of hard and brittle materials.

Research on microscopic fracture mechanism of glass-ceramics grinding surface based on progressive scratch test

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

In Vitro Dental Cutting of Feldspar and Leucite Glass Ceramics Using an Electric Handpiece

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Study on the Model of Surface Crack Depth in Ceramics Grinding

Experimental investigation on grinding-induced surface damage of Fiber Reinforced Ceramic Matrix Composites

Evaluation and Measurement of Surface/Subsurface Crack Damage of Ground Ceramics

Method of Damage Characterization of Engineering Ceramics Grinding Surface

Research of the Grinding Force and Surface Morphology of Fiber-Reinforced Ceramic Matrix Composite

Cross-point effect of high-speed cross scratch on hard brittle materials

Theoretical modeling and experimental analysis of single-grain scratching mechanism of fused quartz glass

Scratch-induced micro-fracture behaviour and translational failure of glass: An experimental and numerical study

Investigation of Surface Integrity Induced by Ultra-Precision Grinding and Scratching of Glassy Carbon

Quantification of micro-damage evolution process in ceramics through extensive analysis of multi-source heterogeneous data

Study on the surface formation mechanism and theoretical model of brittle surface roughness in turning machinable ceramics

Subsurface damage evaluation in the single abrasive scratching of BK7 glass by considering coupling effect of strain rate and temperature

Quasi-brittle fracture performance of glass fiber composites based on boundary effect model

Study on the material removal mechanism and the exit breakage of ultrasonic vibration-assisted grinding for microcrystalline glass

Assessment on flexural performance of monolithic glass considering spatial and depth characteristics of scratches

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon