Abstract:Objective. With the strong drive towards miniaturization of active implantable medical devices and the need to improve the resolution of neural stimulation arrays, there is keen interest in the manufacture of small electrodes capable of safe, continuous stimulation. Traditional materials such as platinum do not possess the necessary electrochemical properties to stimulate neurons safely when electrodes are very small (i.e. typically less than about 300 µm (78 400 µm2)). While there are several commercially viable alternative electrode materials such as titanium nitride and iridium oxide, an attractive approach is modification of existing Pt arrays via a high electrochemical capacitance material coating. Such a composite electrode could still take advantage of the wide range of fabrication techniques used to make platinum-based devices. The coating, however, must be biocompatible, exhibit good adhesion and ideally be long lasting when implanted in the body. Approach. Platinum foils were roughened to various degrees with regular arrays of laser milled pits. Conducting diamond films were grown on the foils by microwave plasma chemical vapor deposition. The adhesion strength of the films to the platinum was assessed by prolonged sonication and accelerated aging. Electrochemical properties were evaluated and compared to previous work. Main results. In line with previous results, diamond coatings increased the charge injection capacity of the platinum foil by more than 300% after functionalization within an oxygen plasma. Roughening of the underlying platinum substrate by laser milling was required to generate strong adhesion between the diamond and the Pt foil. Electrical stress testing, near the limits of safe operation, showed that the diamond films were more electrochemically stable than platinum controls. Significance. The article describes a new method to protect platinum electrodes from degradation in vivo. A 300% increase in charge injection means that device designers can safely employ diamond coated platinum stimulation electrodes at much smaller sizes and greater density than is possible for platinum.

Laser-fabrication of neural electrode arrays with sputtered iridium oxide film

Plasma Enhanced Atomic Layer Deposition of Iridium Oxide for Application in Miniaturized Neural Implants

Electrodeposited iridium oxide for neural stimulation and recording electrodes

Fabrication and Characterization of Platinum-Iridium Electrodes with Micro-Structured Surfaces For Neural Stimulation Applications

Fabrication of High-Performance Neural Stimulation Electrode through Pulsed Electrochemical Deposition of IrOx onto Nano-Porous Platinum

Electrochemical and biological performance of hierarchical platinum-iridium electrodes structured by a femtosecond laser

Iridium nano-oxide as a neural electrode

Substrate arrays of iridium oxide microelectrodes for in vitro neuronal interfacing

A Comparative Study on the Effect of Substrate Structure on Electrochemical Performance and Stability of Electrodeposited Platinum and Iridium Oxide Coatings for Neural Electrodes

Electrochemical Properties of Sputtered Ruthenium Oxide Neural Stimulation and Recording Electrodes

Iridium Oxide-Platinum Nanocomposite Coating for Neural Electrode

Neural Cells on Iridium Oxide

Fabrication and Electrochemical Comparison of SIROF-AIROF-EIROF Microelectrodes for Neural Interfaces

Optimization and electrochemical characterization of RF-sputtered iridium oxide microelectrodes for electrical stimulation

Surface modification of neural stimulating/recording electrodes with high surface area platinum-iridium alloy coatings

Fabrication of ITO microelectrodes and electrode arrays using a low-cost CO2 laser plotter

Long term performance of porous platinum coated neural electrodes

Platinum Nanocrystal Assisted by Low‐Content Iridium for High‐Performance Flexible Electrode: Applications on Neural Interface, Water Oxidation, and Anti‐Microbial Contamination

Electrochemical and biological characterization of thin-film platinum-iridium alloy electrode coatings: a chronic in vivo study

Electrically conducting diamond films grown on platinum foil for neural stimulation

Platinum‐Iridium Alloy Nanoparticle Coatings Produced by Electrophoretic Deposition Reduce Impedance in 3D Neural Electrodes