Abstract:Objective. With the strong drive towards miniaturization of active implantable medical devices and the need to improve the resolution of neural stimulation arrays, there is keen interest in the manufacture of small electrodes capable of safe, continuous stimulation. Traditional materials such as platinum do not possess the necessary electrochemical properties to stimulate neurons safely when electrodes are very small (i.e. typically less than about 300 µm (78 400 µm2)). While there are several commercially viable alternative electrode materials such as titanium nitride and iridium oxide, an attractive approach is modification of existing Pt arrays via a high electrochemical capacitance material coating. Such a composite electrode could still take advantage of the wide range of fabrication techniques used to make platinum-based devices. The coating, however, must be biocompatible, exhibit good adhesion and ideally be long lasting when implanted in the body. Approach. Platinum foils were roughened to various degrees with regular arrays of laser milled pits. Conducting diamond films were grown on the foils by microwave plasma chemical vapor deposition. The adhesion strength of the films to the platinum was assessed by prolonged sonication and accelerated aging. Electrochemical properties were evaluated and compared to previous work. Main results. In line with previous results, diamond coatings increased the charge injection capacity of the platinum foil by more than 300% after functionalization within an oxygen plasma. Roughening of the underlying platinum substrate by laser milling was required to generate strong adhesion between the diamond and the Pt foil. Electrical stress testing, near the limits of safe operation, showed that the diamond films were more electrochemically stable than platinum controls. Significance. The article describes a new method to protect platinum electrodes from degradation in vivo. A 300% increase in charge injection means that device designers can safely employ diamond coated platinum stimulation electrodes at much smaller sizes and greater density than is possible for platinum.

Fabrication and Characterization of Platinum-Iridium Electrodes with Micro-Structured Surfaces For Neural Stimulation Applications

Electrodeposited Platinum Iridium Enables Microstimulation With Carbon Fiber Electrodes

Laser-fabrication of neural electrode arrays with sputtered iridium oxide film

Electrochemical Characterization of Implantable High Aspect Ratio Nanoparticle Platinum Electrodes for Neural Stimulations

Surface modification of neural stimulating/recording electrodes with high surface area platinum-iridium alloy coatings

Electrochemical and biological performance of hierarchical platinum-iridium electrodes structured by a femtosecond laser

Long term performance of porous platinum coated neural electrodes

Electrically conducting diamond films grown on platinum foil for neural stimulation

Fabrication of High-Performance Neural Stimulation Electrode through Pulsed Electrochemical Deposition of IrOx onto Nano-Porous Platinum

Fabrication of Iridium Oxide Neural Electrodes at the Wafer Level

Hierarchical Surface Restructuring of Ultra‐Thin Electrodes and Microelectrode Arrays for Neural Interfacing with Peripheral and Central Nervous Systems

Substrate arrays of iridium oxide microelectrodes for in vitro neuronal interfacing

Penetrating microelectrode arrays with low-impedance sputtered iridium oxide electrode coatings

Anodically Electrodeposited Iridium Oxide Films Microelectrodes for Neural Microstimulation and Recording

High-Performance 3D Platinum Nanostructure Coating on fMEA for Neural Stimulation/Recording

Iridium Oxide-Platinum Nanocomposite Coating for Neural Electrode

Controlled metallic nanopillars for low impedance biomedical electrode

Laser-Induced Periodic Surface Structure Enhances Neuroelectrode Charge Transfer Capabilities and Modulates Astrocyte Function

Fabrication of Bio-Microelectrodes for Deep-Brain Stimulation Using Microfabrication and Electroplating Process

Mechanical and Electrical Stability of Parylene-Based Platinum-Black Coated Wire Microelectrode for Implantable Applications

Batch fabricated thin-film electrodes for stimulation of the central auditory system