Abstract:After the converter steelmaking process, a considerable number of ferroalloys are needed to remove dissolved oxygen from the molten steel, but it also forms a lot of oxide inclusions that cannot be completely removed. At the same time, it increases the carbon emissions in the steel production process. After years of research, our team have developed a series of clean deoxidation technologies, including carbon deoxidation, hydrogen deoxidation, and waste plastic deoxidation of molten steel to address the aforementioned issues. In this study, thermodynamic calculations and laboratory experiments were employed to verify that carbon and hydrogen can reduce the total oxygen content in the molten steel melt to below 5 × 10 −6 and 10 × 10 −6 , respectively. An analysis of the deoxidation mechanisms and effects of polyethylene and polypropylene was also conducted. In addition, the applications of carbon deoxidation technology in different steels with the hot-state experiment and industrial production were discussed carefully. The carbon deoxidation experimental results of different steels were as follows: (1) the oxygen content of bearing steel was effectively controlled at 6.3 × 10 −6 and the inclusion number density was lowered by 74.73% compared to aluminum deoxidized bearing steel; (2) the oxygen content in gear steel was reduced to 7.7 × 10 −6 and a 54.49% reduction of inclusion number density was achieved with almost no inclusions larger than 5 μm from the average level of industry gear steels; (3) a total oxygen content of M2 high-speed steel was as low as 3.7 × 10 −6 . In industrial production practice, carbon deoxidation technique was applied in the final deoxidation stage for non-aluminum deoxidized bearing steel, and it yielded excellent results that the oxygen content was reduced to below 8 × 10 −6 and the oxide inclusions in the steel mainly consist of silicates, along with small amounts of spinel and calcium aluminate.

Experimental investigation on the oxidation process and mechanism of steel billet under oxygen-enriched combustion atmosphere

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

The Ignition Characteristics and Combustion Processes of Coal Gangue under Different Hot Coflow Conditions in O2/CO2 Atmosphere: in Pellet Form

Study on Oxygen-Enriched Combustion Characteristics of Blast Furnace Gas Boiler

Experimental and Kinetic Modeling of Oxygen-Enriched Air Combustion of Municipal Solid Waste.

Computational Fluid Dynamics Study of the Thermochemical Behaviors in an Ironmaking Blast Furnace with Oxygen Enrichment Operation

The Study on High-Temperature Oxidation Law of 20crmo Steel in the Regenerative Heating Furnace

(Digital Presentation) Initial High-Temperature Oxidation Behavior of Iron Binary Alloys in Air

Development and prospects of molten steel deoxidation in steelmaking process

Effects of elevated oxygen content and temperature on the laminar burning velocity of the blast furnace gas in oxygen-enriched air condition

Investigation on the Structure Evolution and Combustion Behavior of Residual Carbon from Entrained-Flow Coal Gasification Fine Slag after Oxidation

Numerical Study of the Reduction Process in an Oxygen Blast Furnace

Simulation research on oxygen mass transfer between steel and slag in IF steel refining process

Isothermal Structure Transformation and Kinetics Behavior of Oxide Scale on Low Carbon Steel

Application of thermal analysis techniques to study the oxidation/reduction phenomena during sintering of steels containing oxygen-sensitive alloying elements

A Study of the Mechanism of Formation of Composite Oxide Scale on Heat-Resistant Steel 25Cr18Ni9Si2

Oxide Scale Formation on Low-Carbon Steels in Future Reheating Conditions

Study on oxygen blowing optimisation of reducing (FeO) content in slag in EAF steelmaking process with high ratio of hot metal to scrap

Effect of furnace atmosphere on sintering process of chromium-containing steel via powder metallurgy

New steelmaking process based on clean deoxidation technology

Investigation on the Combustion Behaviors of Coke and Biomass Char in Quasi-Granule with CuO–CeO2 Catalysts in Iron Ore Sintering