Abstract:Galvanized advanced high strength steels (AHSS) will be the most competitive structural material for automotive applications in the next decade. Oxidation of AHSS during the recrystalization annealing process in a continuous galvanizing line to a large extent influences the quality of zinc coating on the final galvanized steel product. For example, formation of oxides of alloying elements (e.g. Mn, Cr, Si) at the steel surface during annealing prior to galvanizing leads to poor adhesion of a zinc coating. Yet, knowledge on the high temperature oxidation behaviour of AHSS is rather limited. The primary aim of this thesis is to provide fundamental understanding on the kinetics of internal oxidation of AHSS during annealing. The classical Wagner internal oxidation theory for binary alloys was extended to account for multi-component alloys. To this end, a generic coupled thermodynamic-kinetic internal oxidation model based on Fick’s 1st law was developed in order to predict the kinetics of internal oxidation, as well as the concentration depth profiles of internal oxides and solute elements in alloy matrix, considering the finite solubility product of oxide precipitates, the non-ideal behaviour of solid solution and the formation of multiple type of oxide species. The internal oxidation behaviour of Fe-Mn and Fe-Mn-Cr steel alloys were experimentally studied to validate the model. It has been found that for Fe-Mn and Fe-Mn-Cr steel alloys, the effect of non-ideal behaviour of solution on internal oxidation is negligible, and local thermodynamic equilibrium is established within internal oxidation zone. Besides, the kinetics of Wustite formation on pure iron and Mn alloyed steels annealed in CO2 + CO or H2O + H2 gas mixtures as well as the reduction kinetics of the Wustite scale in Ar + H2 gas mixtures were investigated. The growth of Wustite scale on iron and Mn alloyed steels follows the linear rate law. However, adding Mn to iron, even at a relatively low concentration (say 1.7 wt%), dramatically lowers the growth rate of Wustite scale. Nevertheless, reduction kinetics of the Wustite scale on iron and Mn alloyed steels are almost the same. During the reduction process a dense iron layer is formed which separates the remaining Wustite scale from the reduction atmosphere. The rate of Wustite reduction by H2 is controlled by the diffusion of solute oxygen dissolved in the formed iron layer.

(Digital Presentation) Initial High-Temperature Oxidation Behavior of Iron Binary Alloys in Air

Oxidation Mechanism of Three Fe-Al Alloys with and Without Addition of 0.1 At% Yttrium at 800 °C

High‐Temperature Oxidation of 60si2mn Spring Steel in Dry Air and Wet Air: Insights from an Experimental and First‐Principles Study

High-Temperature Oxidation of Steel under Linear Flow Rates of Air and Water Vapor—An Experimental Determined Set of Data

High Temperature Oxidation Behaviors of Steels at Initial Stages in Air

Numerical Model For Short-Time High-Temperature Isothermal Oxidation of Fe–Mn Binaries at High Oxygen Partial Pressure

Investigation of Selective Oxidation During Cooling of Hot-Rolled Iron-Manganese-silicon Alloys

Kinetic Study of Oxide Growth at High Temperature in Low Carbon Steel

Analysis on High-Temperature Oxidation and Growth Stress of Iron-Based Alloy Using Phase Field Method

Oxidation phenomena in advanced high strength steels : Modelling and experiment

Nonlinear Oxidation Behavior in Pure Ni and Ni-Containing Entropic Alloys

Synergetic Kinetics of High-Temperature Surface Degradation Processes in Austenitic Heat-Resistant Cast Steels

High-Temperature Oxidation Properties and Microstructural Evolution of Nanostructure Fe-Cr-Al ODS Alloys

Application of thermal analysis techniques to study the oxidation/reduction phenomena during sintering of steels containing oxygen-sensitive alloying elements

Analysis of Oxide Layer Formation During Oxidation of AISI 4140 Steel at 1000 °C over Exposure Time

Early Stages of High‐Temperature Oxidation Behavior and Its Phase Evolution of 9% Ni Steel

High-Temperature Oxidation Behavior of Iron–Chromium–Aluminum Alloys

High-temperature oxidation behavior and subsurface phase transformation of high-Mn high-Al steel

Characterization of Oxide Scales Formed on Plain Carbon Steels in Dry and Wet Atmospheres and Their Eutectoid Transformation from FeO in Inert Atmosphere

Analysis of corrosion layers on protective coatings and high temperature materials in simulated service environments of modern power plants using SNMS, SIMS, SEM, TEM, RBS and X-ray diffraction studies