Abstract:In this study, the piston-cylinder liner was treated with single glow photoionization sulfurization of a cast aluminum alloy (AlSi10Mg), and the effect of the spherical crown texture on frictional properties of the piston-cylinder liner were investigated before and after the sulfurization treatment. The treated specimens were characterized and evaluated via microscopic morphological analysis, three-dimensional morphological analysis, X-ray diffraction (XRD), thin film diffraction, microhardness testing, and friction wear experiments. Fluent fluid analysis software was used to develop a flow field simulation model for the spherical crown texture. Results of the study showed that the average friction coefficients of the specimens treated with sulfur infiltration were all lower than those of untreated specimens, and the low friction coefficients were closely related to the laminar structure and weak interfacial bonding of the sulfur infiltration layer. The spherical crown structure effectively affected the stree distribution on surface of the specimens uniformly, which improved the bearing capacity and durability of the specimens, and the surface texture helped reduce the contact area and store the debris generated during the wear process, thus improving the friction performance. Mechanical stamping caused material aggregation on the edges of the weave, which increased the hardness of the edges and thus reduces the increase in wear around the weave. The surface microstructure of the specimens was effectively improved after sulfurization treatment, leading to higher wear resistance for the sulfurized specimens. Given the relative lack of research on the composite ionic sulfurization of piston-cylinder liner spherical crown texture at home and abroad, this experiment provides data support for this direction. The results provide beneficial clues for the design and optimization of the piston-cylinder liner spherical crown structure.

Influence of steadite on the tribological behavior of cylinder liners

Synergy Study Between a Lubricant Oil Layer and a Microstructural Graphite to Reduce Friction and Wear of a Thermally Modified Low-Carbon Gray Cast-Iron Cylinder Liner

Effect of spherical crown texturing and ionized sulfur infiltration on the tribological performance of piston-cylinder liner

Tribological Performance and Scuffing Resistance of Cast-Iron Cylinder Liners and Al-Si Alloy Cylinder Liners

Reciprocating sliding friction behavior and wear state transition mechanism of cylinder liner and piston ring

Tribological Performance of Three Advanced Piston Rings in the Presence of MoDTC-modified GF-3 Oils

The Effect of Laser Texturing of Steel Surfaces on Film Lubriction Based on Stribeck Curves

Effect of Triangular Texture on the Tribological Performance of Die Steel with Tin Coatings under Lubricated Sliding Condition

The Effect of Solid-Liquid Composite Lubrication on the Tribological Properties of Bearing Steel

Effects of different surface textures on tribological performances of the cylinder liner-piston ring: An experimental study

Investigation of the solid self-lubricating effect on tribological properties of Al/SiC/Gr composites against steel disc

Coaxial laser cladding of cobalt-base alloy StelliteTM 6 on gray cast iron/investigations on friction, wear versus commercial brake pad, and corrosion characteristics

Investigation of wear behavior of carbide based coated rolling roll materials under dry and lubricated conditions

Tribological Performance of a Composite Cold Spray for Coated Bores

Study on the Tribological Characteristics of Solid Lubricants Embedded Tin‐bronze Bearings

Surface Texturing of Cylinder Liners: A Review

Competitive Surface Interactions of Critical Additives with Piston Ring/Cylinder Liner Components under Lubricated Breaking-In conditions

Researches of Cast Iron Piston Rings Strengthened by Laser

Wear Performance of Cast Iron Piston Rings Strengthened by Laser

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Influence of different loads and temperatures on solid lubricant-filled micro-dimples existing on both cylinder liner and piston ring