Abstract:uThe factor that plays important role in the quality of the final product in selective laser melting (SLM) is the process parameter set used in production. In general, these fabrication parameter sets are obtained experimentally by using the energy density requirements of the material. The experimental investigation is partly a trial and error approach, which is a time and cost-consuming process. On the other hand, keeping the temperature of the melt pool in an allowable range, which is dominated by the applied process parameters sets, and preventing temperature fluctuations impress the stability of the production and therefore the quality of the final product. The paper presents a multiphysics numerical model approach for obtaining parameters in an SLM process by using AlSi10Mg powders as the material medium. The proposed approach provides mathematical relationships between the process parameters and the temperature they form. By investigating the effect of laser power and laser spot diameter on the temperature at different scanning velocities, wider process parameter sets were obtained for AlSi10Mg. In addition, mathematical relationships between laser power-temperature and laser spot diameter-temperature at different scanning velocities, which will be the base material to design a controller to control the melt pool temperature instantly, were developed. By using the parameter sets obtained from the simulations, test samples including samples for microstructure study and tensile test specimens were fabricated to validate the model. The un-melted powders and nonconnected melt pool defects due to insufficient temperature, evaporation defects caused by extreme temperature, and appropriate and homogeneous microstructures as a result of suitable parameters that were predicted through simulations, affecting microstructure and mechanical properties, validated the model. The experimental study was carried out by examining the microstructure and tensile properties of the fabricated test samples.

Selective laser melting process parameter simulation and topology optimization by aerospace component of AlSi10Mg alloy

On the selective laser melting based additive manufacturing of AlSi10Mg: The process parameter investigation through multiphysics simulation and experimental validation

Selective Laser Melting Process Optimization and Mechanical Properties Evolution of AlSi10Mg by Determining Temperature of the Build Chamber using Arduino IDE and Coding Algorithm

Processing AlSi10Mg by selective laser melting: parameter optimisation and material characterisation

Process parameter optimization and mechanical properties for selective laser melting of AlSi10Mg alloy

PARAMETRIC INFLUENCES ON MECHANICAL TRAITS IN SELECTIVE LASER MELTING OF AlSi10Mg

Microstructural analysis and mechanical properties of AlSi10Mg alloy components produced via SLM

On the Selective Laser Melting (SLM) of the AlSi10Mg Alloy: Process, Microstructure, and Mechanical Properties

A review on the simulation of selective laser melting AlSi10Mg

Direct Metal Laser Sintering to Develop Complex Contours of Aisimg Aluminium Alloy - Build Parameters Optimization

Microstructure and Mechanical Properties of Selective Laser Melted Mg-9 Wt%al Powder Mixture

Microstructure, wear and residual stresses of selective laser melting AlSi10Mg solid cylinder

Topology optimization of aerospace part to enhance the performance by additive manufacturing process

Parameter optimization and microhardness experiment of AlSi10Mg alloy prepared by selective laser melting

Simulation of SLM Manufactured Aluminum Process and Optimization of the Parameters by Computational Fluid Dynamics Method

A review on process parameters, microstructure and mechanical properties of additively manufactured AlSi10Mg alloy

Effect of Processing Parameters on Tensile Properties and Microstructure of Selective Laser Melted AlSi10Mg Alloy

Experimental Research on Selective Laser Melting AlSi10Mg Alloys: Process, Densification and Performance

Effects of process parameters on selective laser melting of Ti6Al4V-ELI alloy and parameter optimization via response surface method

Combination of topology and shape optimization with finite element modeling in the case of an aerospace component produced by laser based additive manufacturing

3D printing of Aluminium alloys: Additive Manufacturing of Aluminium alloys using selective laser melting