Abstract:Long-term successful function of artificial hip joint replacements strongly depends on the design parameters of the bearing such as the diameters of femoral head and acetabular cup and the corresponding radial clearance, which determine the lubrication regime experienced in the prostheses. Generally, there are two types of numerical models for elastohydrodynamic lubrication analysis of the bearing in the hip joint replacements: ball-in-socket model and effective ball-on-plane model. As the real hip joint is in ball-in-socket configuration, the ball-in-socket lubrication model should be the reasonable approximation to the real bearing. The ball-in-socket model solves a lubrication problem in spherical coordinates, which means all of governing equations, including Reynolds equation, film thickness and load balance equation, should be written as the spherical coordinate forms. In addition, the calculation of the elastic deformation of the bearing surfaces in artificial joints is not a trial problem. Complex spherical geometries in the joint bearing often require employing the finite element method to determine/extract the displacement influence coefficients at first, and then the deformation is evaluated through using an equivalent discrete spherical convolution model (EDSC). Fortunately, the FFT-based approach is recently developed to speed up the deformation calculation. In comparison with the ball-in-socket model, the effective ball-on-plane model is simple and easy to conduct elastohydrodynamic lubrication analysis. The main characteristic of the effective ball-on-plane model is that the elastic deformation was evaluated under an assumption of semi-infinite solid and certainly without the consideration of the curvature effect associated with the ball-in-socket configuration. In the present study, some typical cases of elastohydrodynamic lubrication analysis for hip joint replacements were conducted to systematically demonstrate the capability of these two models. It was found that the two models were able to provide quite close results in most situations, and the difference may only take place when the head is positioned near the edge of the cup bearing surface.

Implicit Elastoplastic Finite Element Analysis of a Wheel Bearing Shaft Clinching Process Using the Multi-Body Function

Dynamic Analysis of Double-Row Self-Aligning Ball Bearings Due to Applied Loads, Internal Clearance, Surface Waviness and Number of Balls

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Modeling and analysis of planar multibody systems containing deep groove ball bearing with clearance

Rigid–viscoplastic Dynamic Explicit FEA of the Ring Rolling Process

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

Multi-body contact modeling and statistical experimental validation for hub-bearing unit

Finite element modeling and analysis for the integration–rolling–extrusion process of spline shaft

Analysis and Evaluation of Multi-state Wear Mechanism of Elastic-flexible Thin-walled Bearings

Dynamic modeling and error analysis of planar flexible multilink mechanism with clearance and spindle-bearing structure

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

Finite Element Simulation of Radial Tire Building and Shaping Processes Using an Elasto-Viscoplastic Model

Finite Element Simulation and Microstructural Analysis of Roll Forming for DP590 High-Strength Dual-Phase Steel Wheel Rims

The 3-D finite element analysis of press fitting process in railway wheel-set

Local Stress Analysis of A Defective Rolling Bearing Using an Explicit Dynamic Method

Numerical analysis of stresses on angular contact ball bearing under the static loading with respect to race thickness and housing stiffness

Iterative Method to Solve Beating's Force and Stiffness for a Multi-Support Spindle System Based on Finite Element Analysis

Coupled thermal-mechanical FEM analysis on multi-way loading forming process of triple valve body

Numerical Lubrication Simulation of Metal-on-Metal Hip Joints: Ball-in-Socket Model and Ball-on-Plane Model

Multi-body Dynamic Modelling and Error Analysis of Planar Flexible Multilink Mechanism Considering Clearance and Thermal-mechanical Coupling Effect of the Crankshaft-bearing Structure

The Gear Shaft Numerical Simulation Based on the Elastoplasticity Finite Elements Method