Abstract:<div><div>Understanding the aerodynamic impact of swept-wing ice accretions is a crucial component of the design of modern aircraft. Computer-simulation tools are commonly used to approximate ice shapes, so the necessary level of detail or fidelity of those simulated ice shapes must be understood relative to high-fidelity representations of the ice. Previous tests were performed in the NASA Icing Research Tunnel to acquire high-fidelity ice shapes. From this database, full-span artificial ice shapes were designed and manufactured for both an 8.9%-scale and 13.3%-scale semispan wing model of the CRM65 which has been established as the full-scale baseline for this swept-wing project. These models were tested in the Walter H. Beech wind tunnel at Wichita State University and at the ONERA F1 facility, respectively. The data collected in the Wichita St. University wind tunnel provided a low-Reynolds number baseline study while the pressurized F1 facility produced data over a wide range of Reynolds and Mach numbers with the highest Reynolds number studied being approximately <i>Re</i> = 11.9×10<sup>6</sup>. Past work focused on only three different fidelity variations for ice shapes based on multiple icing conditions. This work presents a more detailed investigation into several fidelity representations of a single highly three-dimensional scallop ice accretion. Sensitivity to roughness size and application technique on a low-fidelity smooth ice shape is described. The data indicate that the aerodynamic performance is not especially sensitive to the grit variations. An ice accretion code was also used to generate ice shapes for aerodynamic testing and comparisons. These ice shapes have a general appearance like the low-fidelity smooth ice shapes, but in this case, the computer-generated ice shape is significantly smaller. As such, the impact of that ice shape on the aerodynamic performance of the wing is reduced compared to the smooth ice shape based on the icing experiment for those same conditions. Spanwise discontinuities were also introduced to a low-fidelity ice shape in an attempt to quantify the impact of those variation in the high-fidelity ice shape. While the lift data indicate good agreement between the high-fidelity ice shapes and the low-fidelity ice shapes with spanwise discontinuities, a closer investigation of the data suggests potential, significant differences in the flowfield. These results were similar at both facilities over the wide range of test conditions utilized.</div></div>

Ice accretion panel model for cylinders at low Reynolds numbers

The effect of icing on small unmanned aircraft low Reynolds number airfoils

Development of a Computational Fluid Dynamics Model for Ice Formation: Validation and Parameter Analysis

A New Ice Accretion Model for Aircraft Icing Based on Phase-Field Method

Aerodynamic prediction and roughness implementation toward ice accretion simulation

Effects of Surface Roughness on Splashing Characteristics of Large Droplets with Digital Inline Holographic Imaging

An Ice Accretion Model for Aircraft Icing Based on Supercooled Icing: Theory and Application

Numerical Investigation of Ice Accretion Effects at Supercooled Large Droplet Conditions

Influence of Air Flow Field Computation on an Ice Accretion Simulation of Airfoils

An enthalpy-based model for the physics of ice crystal icing

Multi-physics simulation of in-flight ice shedding

Numerical Icing Simulations of Cylindrical Geometry and Comparisons to Flight Test Results

Ice accretion simulation incorporating roughness effects and separation correction through a transition model

Model for Aircraft Icing with Consideration of Property-Variable Rime Ice

A Numerical Study of Droplet Impingement for In-Flight Ice Accretion Prediction

Development and Theoretical Analysis of an Aircraft Supercooled Icing Model

Finite volume based film flow and ice accretion models on aircraft wings

Experimental Aerodynamic Simulation of a Scallop Ice Accretion on a Swept Wing

Prediction of ice accretion and aerodynamic performance analysis of NACA 2412 aerofoil

Unsteady numerical simulations of aircraft icing based on the dynamic grid method

Numerical Simulation of Iced Wing Using Separating Shear Layer Fixed Turbulence Models