Abstract:The impact of supercooled water droplets is the cause of aircraft icing, and the acquisition of impingement characteristics is the key to icing prediction and the design of ice protection systems. The introduction of water droplet collection efficiency is required to obtain the characteristics for the Lagrangian method. In this work, a traditional flow tube method, a local flow tube method, and a statistical method are established to calculate the local collection efficiency, based on Lagrangian droplet trajectories. Through the numerical simulations of the air–droplet flow field around an NACA 0012 airfoil, the accuracies of the three methods in regard to collection efficiency are verified. Then, these three methods are applied to obtain the results for water droplet trajectories and the collection efficiency of an S-shaped duct, a 2D engine cone section and an icing wind tunnel. The results show that the distributions of water droplet collection efficiency obtained by the three methods are consistent and the three methods are all feasible when the water droplets do not overlap or cross before hitting the aircraft surfaces. When the water droplets are shadowed by upstream surfaces or blown by air injection, the droplet trajectories might overlap or even cross, and the local collection efficiencies obtained by the traditional flow tube method, local flow tube method, and statistical method might differ. The statistical method is relatively accurate. However, not all the droplet impingement characteristics obtained by the three methods are different due to these effects, and the non-crossing of the droplet trajectories is not a necessary condition for the use of the flow tube method. The effects of trajectory crossings are analyzed and discussed in detail in different situations for the three methods. This work is helpful for understanding and accurately calculating the droplet impingement characteristics and is of great significance for simulations of the aircraft icing process and anti/de-icing range.

A Numerical Study of Droplet Impingement for In-Flight Ice Accretion Prediction

Analysis of Numerical Methods for Droplet Impingement Characteristics under Aircraft Icing Conditions

Numerical Investigation of Ice Accretion Effects at Supercooled Large Droplet Conditions

Research on the Methods for Obtaining Droplet Impingement Characteristics in the Lagrangian Framework

Influence of Air Flow Field Computation on an Ice Accretion Simulation of Airfoils

Numerical Study of Violent Impact Flow Using a CIP-Based Model

Numerical Investigation of Supercooled Large Droplets Impingement Characteristics of the Rotating Spinner

Effects of Surface Roughness on Splashing Characteristics of Large Droplets with Digital Inline Holographic Imaging

Numerical simulation of droplet impingement and film flow for three-dimensional wings

Aerodynamic prediction and roughness implementation toward ice accretion simulation

Numerical Simulation of Ice Accretion on Wings and Flow Field Analysis

Numerical Simulation of Iced Wing Using Separating Shear Layer Fixed Turbulence Models

Supercooled large droplet size distribution effects on airfoil icing: A numerical investigation based on a new coupled Eulerian method

A Numerical Study of Water Entry of Asymmetric Wedges Using a CIP-based Model

A New Ice Accretion Model for Aircraft Icing Based on Phase-Field Method

Ice accretion simulation incorporating roughness effects and separation correction through a transition model

Numerical Simulation of Water Film Flow and Breakup on Anti-Icing Surface

Development of a Computational Fluid Dynamics Model for Ice Formation: Validation and Parameter Analysis

Numerical simulation of droplet impinging icing process on a low-temperature wall with smoothed particle hydrodynamics (SPH) method

Numerical Simulation of Ice Crystal Supercooled Droplet Mixed Phase Icing Based on the Improved Messinger Model

Finite volume based film flow and ice accretion models on aircraft wings