Abstract:When measuring the thermal conductivity of thermal insulation materials made by powder metallurgy and building porous materials, complications arise due to the fact that heat flows through the samples are commensurate with heat losses. The steady-state heat flow (SSHF) method is simple, does not require sophisticated equipment, and allows determining the thermal conductivity not in the near-surface layer but in the entire sample volume. Its disadvantage is low accuracy and the need to use reference samples. This work aims to develop an installation for measuring the thermal conductivity of largesized samples of low-conductivity material using the steady-state heat flow method with significantly higher accuracy than existing installations using this method. This is achieved by sandwiching the sample, which is a thin square plate of large dimensions, between the heater chamber and the refrigerator. The heating chamber is made of insulating material and its front wall, which is in contact with the sample, is made of the copper plate (which has good thermal conductivity). In the operating mode, the temperature in the heater chamber is maintained equal to the ambient temperature, which allows us to neglect heat losses and assume that in the steady-state mode, the heater power is equal to the heat flux through the sample. The thickness of the sample is much smaller than the size of its side (the sample should be square). This assumption is necessary to use the condition of isotropic temperature distribution in the cross-section of the sample. The refrigerator is filled with water and ice. The isotropic temperature distribution in the sample is ensured by its contact with the copper walls of the heater and refrigerator chamber. The temperature of the heated surface of the sample is measured using a thermocouple inserted through a hole in the front wall of the heater chamber. The proposed design of the installation and its operating conditions make it possible to significantly improve the accuracy of determining the thermal conductivity coefficient and make the error less than 2%.

Methodology for measuring the thermal conductivity of insulating samples with small dimensions by heat flow meter technique

Research On Thermal Conductivity Measurement Of Submicrometer-Scale Silicon Dioxide Film In Thermal Flow Sensor By Micro-Raman Technique

INSTALLATION FOR DETERMINING THE THERMAL CONDUCTIVITY OF PLATES BY THE STATIONARY METHOD

Determination of thermal conductivity, thermal diffusivity, and specific heat of liquids using a thermoelectric module

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance

Quantitative Measurement of Thermal Conductivity by SThM Technique: Measurements, Calibration Protocols and Uncertainty Evaluation

A New Metre for Cheap, Quick, Reliable and Simple Thermal Transmittance (U-Value) Measurements in Buildings

Simultaneous thermal conductivity and specific heat measurements of thin samples by transient Joule self-heating

Computational characterisation of the heat flow meter method applied to moist bio-based insulating building materials

Hassle-free Approach to Thermal Transport Measurements Using Spatial-Temporal Temperature Data

Design of Thermal Liquid Flow Microsensor

A Small-Plane Heat Source Method for Measuring the Thermal Conductivities of Anisotropic Materials

Measurement Techniques for Thermal Conductivity and Interfacial Thermal Conductance of Bulk and Thin Film Materials

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

Development of an Energy-Efficient and Highly Sensitive Thermal Microsensor for Measuring Flow Rates of Fluids

Measuring the thermal diffusivity in a student laboratory

A Novel Method of Accurately Characterizing Heat Pipes Using Thermoelectric Modules

Thermal Test Apparatus for Mini Heat Sinks

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Analysis and Improvement of the Hot Disk Transient Plane Source Method for Low Thermal Conductivity Materials

Accurate measurement of thermal conductivity of micro-quantity liquids by dielectric transient current method