Abstract:Abstract Wear particle-induced osteolysis is the main reason for the long-term failure of total knee replacement. Simulator testing is the standard procedure for validating wear performance pre-clinically. The load and kinematics specified in the International Organization for Standardization (ISO) are standard input profiles for wear testing of implants. Directions of internal–external (IE) rotation and anterior–posterior (AP) translation have been modified in the new version of ISO 14243-3 2014. This study focused on investigating the effects of internal–external rotation and anterior–posterior translation on the wear of knee implants. Numerical wear prediction was performed using the finite element model along with two wear models, namely the contact pressure independent model and contact pressure dependent model. Addition of internal–external rotation significantly increased the wear, and the two wear models obtained similar results. The effect of internal–external rotation direction on wear was slight. Forward movement of the tibial insert during flexion decreased the wear under the contact pressure independent model and increased the wear under the contact pressure dependent model. When the AP direction switched, the two models obtained opposite wear tendencies. The results predicted by the contact pressure dependent model were consistent with those of wear tendency experiments reported in the literature. Further investigation of wear physical principles was necessary to gain a more reliable model. This study demonstrated that both internal–external rotation and anterior–posterior translation were pivotal factors influencing the contact mechanism and wear of total knee implants. More realistic kinematics are necessary for accurate wear assessment.

A bidirectional wear model based on Inverse Gaussian (IG) process for PEEK against AISI630 stainless steel in seawater hydraulic components

Tribological behavior of modified polyetheretherketone composites in sliding against stainless steel under water lubrication

Reliability assessment of PEEK/17-4PH stainless steel tribopair under seawater lubrication

Modeling of contact temperatures and their influence on the tribological performance of PEEK and PTFE in a dual-pin-on-disk tribometer

Tribocorrosion Behavior of Several Corrosion-resistant Alloys Sliding Against CF-PEEK: Application for Hydraulic Valve in Seawater

The Difference in Tribological Characteristics between CFRPEEK and Stainless Steel under Water Lubrication in Friction Testing Machine and Axial Piston Pump

Tribological Behavior and Lubricating Mechanism of Si3N4 in Artificial Seawater

Initiation and Evolution of Interference Wear and Pitting for Spur Gears Considering the Concurrent Effects of Meshing Impact and Mixed Lubrication

Failure analysis and improvement of the tribological performance of sliding bearing tribopair in integrated energy recovery-pressure boost device

Influence of bionic non-smooth surface texture on tribological characteristics of carbon-fiber-reinforced polyetheretherketone under seawater lubrication

Influence of Cross-Shear and Contact Pressure on Wear Mechanisms of PEEK and CFR-PEEK in Total Hip Joint Replacements

Correlating numerical modelling with experimental studies to quantify the wear resistance of high-carbon chromium bearing steel in mixed lubrication

Effect of Micro-Textured Surfaces and Sliding Speed on the Lubrication Mechanism and Friction-Wear Characteristics of CF/PEEK Rubbing against 316L Stainless Steel under Seawater Lubrication

Effect of different loads on wear mechanisms of polyether-ether-ketone in normal saline and debris-isolating method

Computational Wear Prediction for Impact of Kinematics Boundary Conditions on Wear of Total Knee Replacement Using Two Cross-Shear Models

Prediction and Experimental Validation of Aviation Floating Involute Spline

Modeling and Simulation of Wear in PTFE Lip Seals

An Experimental Investigation on the Wear of Lubricated Steel Against PEEK Gears

Aqueous lubrication and surface microstructures of engineering polymer materials (PEEK and PI) when sliding against Si3N4

Dynamic computational wear model of PEEK-on-XLPE bearing couple in total hip replacements

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings