Abstract:A novel design of the gas inlet system in a diamond microwave plasma chemical vapor deposition growth chamber has been reported in this paper. The design is targeting for high-quality, high-speed, and high-efficiency diamond material fabrication. By introducing a gas inlet hole into the susceptor, we expand the ways of gas introduction for diamond growth. After extensive numerical and experimental investigation, we have found that the introduction of methane and doping gas inlet from the hole of below while the hydrogen from the top is feasible for realizing the target. The growth and doping species could be confined around the substrate, making efficient usage of the precursors. The plasma state change caused by the difference of the gas inlet modes has been ascribed to the resulted gas distribution in the chamber. The measured growth rate has been increased to 32 μm/h, which is 16 times higher than traditional gas inlet configuration. Meanwhile, a large improvement of the nitrogen doping concentration has been achieved. Besides, with the increase of growth rate and nitrogen incorporation efficiency, the crystal quality and surface morphology keep in an acceptable degree. In this mode, the dual gas flow system can perfectly solve the contradiction among the crystal quality, growth rate, and doping efficiency, commonly existing during the material fabrication process, the chamber contamination could be significantly suppressed due to the constrained distribution of methyl and doping species, making the fabrication cost much lower. The results of repetitive experiments indicate that other residual impurities present in the chamber of MPCVD could likely regulate the threshold concentration of nitrogen required for accelerating the growth rate during the nitrogen doped diamond growth, which have a significant effect on the diamond growth.

Effective cooling of substrates with low thermal conductivity under conditions of gas-jet MPCVD diamond synthesis

Gas-jet MPCVD synthesis of diamond coatings on substrates of various materials

GAS-JET SYNTHESIS OF DIAMOND COATINGS ON SILICON SUBSTRATES FROM AN H2 + CH4 + Ar MIXTURE ACTIVATED IN A MICROWAVE DISCHARGE

Effect of methane flow rate on gas-jet MPCVD diamond synthesis

Study on the Simulation and Experimental Impact of Substrate Holder Design on 3-Inch High-Quality Polycrystalline Diamond Thin Film Growth in a 2.45 GHz Resonant Cavity MPCVD

Growth of diamond microchannels on micro-grooved graphite substrate by MPCVD

Investigation on growth rate and quality of diamond materials in MPCVD system

Optimizing MPCVD Systems for Diamond Growth Through Advanced Microwave Transmission Theory

Significant suppression of residual nitrogen incorporation in diamond film with a novel susceptor geometry employed in MPCVD

An innovative gas inlet design in a microwave plasma chemical vapor deposition chamber for high-quality, high-speed, and high-efficiency diamond growth

Preparation of diamond on GaN using microwave plasma chemical vapor deposition with double-substrate structure

Diamond-Like Carbon Thin-Film Deposition Using A Magnetically Confined Rf Pecvd System

Effect of frequency on low temperature synthesis of diamond by pulsed discharge MPCVD

Effects of the electric field at the edge of a substrate to deposit a Ø100 mm uniform diamond film in a 2.45 GHz MPCVD system

Low-temperature Β-Sic Interlayer for Diamond Film on Cemented Carbide

Optimization Design of MPCVD Single Crystal Diamond Growth Based on Plasma Diagnostics

THE DEVELOPMENT OF MICROWAVE PLASMA CHEMICAL VOPOR DEPOSITION FACILITIES FOR DIAMOND FILMS

Investigation of the Cooling Enhancement of a Single Crystal Diamond Heat Sink with Embedded Microfluidic Channels

Surface treatment of an applied novel all-diamond microchannel heat sink for heat transfer performance enhancement

Growth of 2-inch diamond films on 4H–SiC substrate by microwave plasma CVD for enhanced thermal performance

MPCVD diamond-SiC composite stacks for enhanced thermal performance: a concise review