Abstract:A novel design of the gas inlet system in a diamond microwave plasma chemical vapor deposition growth chamber has been reported in this paper. The design is targeting for high-quality, high-speed, and high-efficiency diamond material fabrication. By introducing a gas inlet hole into the susceptor, we expand the ways of gas introduction for diamond growth. After extensive numerical and experimental investigation, we have found that the introduction of methane and doping gas inlet from the hole of below while the hydrogen from the top is feasible for realizing the target. The growth and doping species could be confined around the substrate, making efficient usage of the precursors. The plasma state change caused by the difference of the gas inlet modes has been ascribed to the resulted gas distribution in the chamber. The measured growth rate has been increased to 32 μm/h, which is 16 times higher than traditional gas inlet configuration. Meanwhile, a large improvement of the nitrogen doping concentration has been achieved. Besides, with the increase of growth rate and nitrogen incorporation efficiency, the crystal quality and surface morphology keep in an acceptable degree. In this mode, the dual gas flow system can perfectly solve the contradiction among the crystal quality, growth rate, and doping efficiency, commonly existing during the material fabrication process, the chamber contamination could be significantly suppressed due to the constrained distribution of methyl and doping species, making the fabrication cost much lower. The results of repetitive experiments indicate that other residual impurities present in the chamber of MPCVD could likely regulate the threshold concentration of nitrogen required for accelerating the growth rate during the nitrogen doped diamond growth, which have a significant effect on the diamond growth.

Growth of diamond microchannels on micro-grooved graphite substrate by MPCVD

Fabrication of Microchannels in Single Crystal Diamond for Microfluidic Systems

Progress of Diamond Substrate Development

High-quality fabrication of diamond straight microchannels heat sink with large aspect ratio microchannels using UV nanosecond laser based on multi-feed method

Preparation of diamond on GaN using microwave plasma chemical vapor deposition with double-substrate structure

High-speed growth of high-quality polycrystalline diamond films by MPCVD

Diamond Films and Particles Growth in Hydrogen Microwave Plasma with Graphite Solid Precursor: Optical Emission Spectroscopy Study

Vertical-substrate Epitaxial Growth of Single-Crystal Diamond by Microwave Plasma-Assisted Chemical Vapor Deposition

Optimizing MPCVD Systems for Diamond Growth Through Advanced Microwave Transmission Theory

Vertical-Substrate MPCVD Epitaxial Nanodiamond Growth

An innovative gas inlet design in a microwave plasma chemical vapor deposition chamber for high-quality, high-speed, and high-efficiency diamond growth

Growth of highly oriented graphite by ultraviolet nanosecond pulsed laser ablation of monocrystalline diamond

Recent progress in homoepitaxial single-crystal diamond growth via MPCVD

Multi-Parameters Optimization for Diamond Microchannel Heat Sink

Vapor phase nucleation and sedimentation of dispersed nanodiamonds by MPCVD

Optimization of deposition parameters for the growth of micro-edge diamond abrasive grains using HFCVD method

Fabrication of hundreds of microns three-dimensional single crystal diamond channel along with high aspect ratio by two-step process

Fabrication of silicon carbide microchannels by thin diamond wheel grinding

The Effects of Deposition Parameters on the Grain Morphology and Wear Mechanism of Monolayer Diamond Grinding Tools Fabricated by Hot Filament CVD Method

H-Terminated Diamond MOSFETs on High-Quality Diamond Film Grown by MPCVD

Microcontact printing fabrication of diamond MEMS cantilevers on silicon substrate