Abstract:A medium ash coal is used for the study. Four different samples have prepared by blending fine fraction (<38 µm) with four distinct coarse fractions (212 µm – 300 µm, 90 µm – 300 µm, 150 µm – 212 µm,75 µm – 150 µm) in the ratio of 40:60 and named as sample 1, sample 2, sample 3, sample 4, respectively. These four samples mixed with mixture of natural and chemical additive solution, i.e. saponin from shikakai and SDBS (sodium dodecyl benzene sulfonate) to reduce the viscosity and increase the stability of the slurry. The flow behavior of coal water slurry were characterized at different coal loadings, pH, dispersant contents with and without presence of mixture of bio and chemical additive. The flow behavior of the slurry studied in the solid concentration range of (58–68) % by weight and the behavior is well fitted to the Bingham plastic model which indicates non-Newtonian behavior in nature. Out of four samples, sample 1 shows maximum coal loading, i.e. 68% in the presence of mixture of additive, i.e. saponin and SDBS. For the solid loading of 68% by weight the apparent viscosity is 1.3 PaS for the shear rate 147 S−1. The ratio of saponin and SDBS is optimized on the basis of surface tension measurement and apparent viscosity of coal water slurry. During surface tension measurement the value of surface tension is 14 mN/m at the point of optimization of surfactant mixture percentage, i.e. saponin:SDBS = 92:8 and the viscosity of the surfactant/additive mixture at this optimization point is 0.403 Pa.S. The rheological behavior of the slurry has been measured. Effect of zeta potential of the coal particle has been studied in the presence of mixture of additive solution (saponin and SDBS). A suitable mechanism has given to explain the interaction between additive solution and coal surface.

The Effect of Selective Additives on the Rheological Behavior of Power Plant Ash Slurry

Impact of anthracite blending and SDS addition on slurryability and stability of Indian high ash coal water slurry

Effect of mixture of natural and synthetic surfactant and particle size distribution for stabilized high-concentrated coal water slurry

Effect of mixture of a non-ionic and a cationic surfactant for preparation of stabilized high concentration coal water slurry

Effect of Silica Flour and Potasium Chloride as Additives in the Rhelogical Properties of High Temperature High Pressure Gas Well Cement Slurry

The Influence of Rheology for Different Superplasticizer on High Alumina Low Cement Castable

Effects of Powder Surface Modification and Amount of Oxide Additives on Rheological Property of Si<sub>3</sub>N<sub>4</sub> Aqueous Suspension

Effect of Rice Husk Ash on the Properties of Alkali-Activated Slag Pastes: Shrinkage, Hydration and Mechanical Property

Effect of Rice Husk Ash Surface Modification by Silane Coupling Agents on Damping Capacity of Cement-Based Pastes

Rheological properties of cement-based slurry and evaluation of rheological model: Influence of particle size and shape

Investigation of Biomass Ash Sintering Characteristics and the Effect of Additives

Effect of Rice Husk Ash on Properties of Slag Based Geopolymer Pastes

Rheological performance and hydration kinetics of lithium slag-cement binder in the function of sodium sulfate

Effect of Steel Slag on Hydration Kinetics and Rheological Properties of Alkali-Activated Slag Materials: A Comparative Study with Fly Ash

Effects of Silica Fume/ultrafine Fly Ash on the Rheology and Hardening of Alkali-Activated Slag-Waste Ceramic Powder Paste

Rheological Behavior of Clay Tailings in the Presence of Divalent Cations and Sodium Polyacrylate: Insights from Molecular Dynamics Simulations

Sustainable Transportation, Leaching, Stabilization, and Disposal of Fly Ash Using a Mixture of Natural Surfactant and Sodium Silicate

Microstructure and Phase Characterization of Alkali-Activated Slag–Fly Ash Materials with Tetrasodium of 1-Hydroxy Ethylidene-1, 1-Diphosphonic Acid (HEDP·4Na)

Effect of activator on rheological properties of alkali-activated slag-fly ash pastes

Effects of anionic species of activators on the rheological properties and early gel characteristics of alkali-activated slag paste

Rheological Properties of Oil Sand Slurries and the Effect on Viscosity of Blending with Coal