Abstract:A medium ash coal is used for the study. Four different samples have prepared by blending fine fraction (<38 µm) with four distinct coarse fractions (212 µm – 300 µm, 90 µm – 300 µm, 150 µm – 212 µm,75 µm – 150 µm) in the ratio of 40:60 and named as sample 1, sample 2, sample 3, sample 4, respectively. These four samples mixed with mixture of natural and chemical additive solution, i.e. saponin from shikakai and SDBS (sodium dodecyl benzene sulfonate) to reduce the viscosity and increase the stability of the slurry. The flow behavior of coal water slurry were characterized at different coal loadings, pH, dispersant contents with and without presence of mixture of bio and chemical additive. The flow behavior of the slurry studied in the solid concentration range of (58–68) % by weight and the behavior is well fitted to the Bingham plastic model which indicates non-Newtonian behavior in nature. Out of four samples, sample 1 shows maximum coal loading, i.e. 68% in the presence of mixture of additive, i.e. saponin and SDBS. For the solid loading of 68% by weight the apparent viscosity is 1.3 PaS for the shear rate 147 S−1. The ratio of saponin and SDBS is optimized on the basis of surface tension measurement and apparent viscosity of coal water slurry. During surface tension measurement the value of surface tension is 14 mN/m at the point of optimization of surfactant mixture percentage, i.e. saponin:SDBS = 92:8 and the viscosity of the surfactant/additive mixture at this optimization point is 0.403 Pa.S. The rheological behavior of the slurry has been measured. Effect of zeta potential of the coal particle has been studied in the presence of mixture of additive solution (saponin and SDBS). A suitable mechanism has given to explain the interaction between additive solution and coal surface.

Rheological Properties of Oil Sand Slurries and the Effect on Viscosity of Blending with Coal

Study on the Slurrying and Rheological Properties of Coal–oilfield Wastewater–slurry

Viscosity Modification of Lubricating Oil Based on High-Concentration Silica Nanoparticle Colloidal System

An Investigation on Characteristics of Coal–water Slurry Prepared from the Solid Residue of Plasma Pyrolysis of Coal

Effects of Modified Sodium Lignosulfonate on Rheological Properties of Coal–Water Slurry with Low-Rank Coal

ANALYSIS OF SOME FACTORS AFFECTING CWS VISCOSITY

Influence of impurities on viscosity of oil sludge

Rheology and Thixotropic Properties of Slurry Fuel Prepared Using Municipal Wastewater Sludge and Coal

Slurrying characteristics of low-volatile coal and the rheological characteristics of coal water slurry

Effects of Blending Coals on the Behavior of Coal Water Slurry

Influence of Wet Sludge on the Slurrying Properties of Coal-Water Slurries

Slurryability of Petroleum Coke and Rheological Characteristics and Stability of PCWS

Eco-friendly utilization of waste oil for preparing coal water slurry: Additive suitability and dispersion mechanism

Slurry characteristics and mechanism analysis of petroleum coke-coal water slurry

Study on basic features of sludge coal water slurry

Effects of particle filling and gradation on the properties of coal-water slurries blended with semicoke

The Slurrying Properties of Coal Water Slurries Containing Raw Sewage Sludge

Effect of mixture of natural and synthetic surfactant and particle size distribution for stabilized high-concentrated coal water slurry

The utilization of sewage sludge by blending with coal water slurry

Slurryability and Influencing Mechanism of Hydrophobic Structures in Additive–Coal–Water Ternary System

Study on Rheological Characteristics of Petroleum Coke Residual Oil Slurry