Abstract:Particulate emissions from homogeneous charge compression ignition (HCCI)engines are often considered as negligible and the measurement of particulate matter (PM) with HCCI combustion systems has been rare. An earlier publication in the literature and the authors' own recently published work suggest that PM emissions from gasoline direct injection (DI) HCCI engines should not be neglected. It has been shown that PM emissions from HCCI engines, although generally lower, can be similar to spark ignition (SI) levels for certain engine conditions, especially in the accumulation mode. The present work shows that although injection timing is effective for control of HCCI, it can have a significant impact on PM emissions. Engine speed also appears to have an impact on PM emissions for the HCCI combustion mode. Typically for HCCI operating at 1500 r/min, the total mass and total number of the PM emissions could be up to six times higher when the fuel is injected during the recompression period compared with the case for injection during the inlet valve open period. Similarly, when the engine was operated in SI mode, an attempt to inject fuel close to induction top dead centre (TDC) made the PM emission noticeably higher, reaching unacceptable levels. The split injection strategy for HCCI mode has been investigated for its effect on PM emissions. It has been found that the PM. number concentration for split injection lies between the maximum concentration measured for very early injections (near TDC at recompression) and the minimum concentration measured for the latest injections used (at crank angles near to the inlet valve maximum opening time), with the magnitude of number density varying approximately from 0.2 to 1.2 million/cm(3). It is also observed that for split injection the number of particulates in nucleation mode varies less, while the number in accumulation mode level varies within a limit of one order of magnitude; both are dependent on the injection strategy. The shape of the PM distribution is such that the nucleation mode exceeds the number concentration of 1 x 10(7) (dN d log D-p) and the accumulation mode falls parabolically to approximately 1 x 10(6). For comparison, it can be said that the PM number concentration measured in the authors' engine is approximately one order of magnitude lower in accumulation mode than the level for a typical modern diesel engine.

Effect of Operation Strategy on First Cycle CO, HC, and PM/PN Emissions in a GDI Engine

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Effects of multiple injection strategies on gaseous emissions and particle size distribution in a two-stroke compression-ignition engine operating with the gasoline partially premixed combustion concept

Effect Of Injection Timing On Gasoline Homogeneous Charge Compression Ignition Particulate Emissions

Investigation of Injection Parameters Coupled with Fuel Reactivity on Combustion and Emissions in Dual Direct-Injection GCI Engine

A Novel Valve Strategy for Particulate Matter Reduction in a Gasoline Direct Injection Engine Operated at Cold Conditions

Effects of Injection Timing and Fuel Pulse Width on Mixture Preparation and Hydrocarbon Emissions of the First Cranking Cycle under Different Initial Piston Positions

The Effect of Control Strategies on the Gasoline Compression Ignition (GCI) Engine: Injection Strategy, Exhaust Residual Gas Strategy, Biodiesel Addition Strategy, and Oxygen Content Strategy

Optimising the Particulate Emission Characteristics of a Dual-Fuel Spark Ignition Engine by Changing the Gasoline Direct Injection Strategy

Effect of Injection Strategy on Emission Characteristics of Compression Ignition Engine Fueled with Blended Fuel

Impact of Fuel and Injection System on Particle Emissions from A Gdi Engine

Effects of Multiple Injections on the Combustion and Hydrocarbon Emission Characteristics of the Start Cylinder in Direct-Start Process

An Experimental Study on Combustion and Particulate Emissions Characteristics on a Dual-Injection Gasoline Engine

Effects of different injection strategies on mixing, combustion and emission behavior of gasoline compression ignition (GCI) engines

Effect of Post-Injection on Combustion and Exhaust Emissions in DI Diesel Engine

Effect of multi-injection strategy on characteristics of methanol-fueled direct injection spark ignition engine

Effects of Dual Injection Operations on Combustion Performances and Particulate Matter Emissions in a Spark Ignition Engine Fuelled with Second-Generation Biogasoline

Influence of Injection Parameters on Combustion, Gaseous Emissions and Particle Size Distribution of a CRDI Diesel Engine Operating with PODE/diesel Blends

The Impact of Fuel and Injection Strategy on Combustion Characteristics, Emissions and Efficiency in Gasoline Compression Ignition Operation

Gasoline Compression Ignition (GCI) Combustion in a Light-Duty Engine Using Double Injection Strategy