Abstract:Many thermal power plants use selective catalytic reduction (SCR) systems to complete flue gas denitration. The system has the characteristics of large inertia, large delay and nonlinearity. At the same time, it is difficult to use the controller under a single working condition to meet the control task of the system under the full working conditions. In order to solve the above control difficulties, This paper proposes a two-degree-of-freedom internal model control (2-DOF-IMC) method based on controller parameter adaptation and multi-model adaptation to realize the control of the full working conditions of the SCR system. First, the intelligent identification method based on Differential evolution quantum particle swarm optimization (DEQPSO) is used to obtain the sub-model of ammonia injection-SCR outlet Nitrogen Oxide (NOx) concentration in typical working conditions. A 2-DOF-IMC controller under each sub-model is established. Then, aiming at system set point tracking performance, anti-disturbance performance, and control energy consumption, the Pareto optimal solution of each controller is obtained by using the Non-dominated Sorting Genetic Algorithms-II (NSGA-II) algorithm based on chaotic mutation. Finally, the controller parameter adaptive strategy is designed based on the Takagi-Sugeno (T-S) fuzzy model, and the multi-model adaptive strategy is designed based on the recursive bayesian probability weighting. Through the dynamic performance test and the anti-disturbance performance test, it is verified that the 2-DOF-IMC based on controller parameter adaptation and multi-model adaptation has good control performance and adaptability to all working conditions. The method proposed in this paper combines the advantages of multi-parameter and multi-model strategies, further improves the control quality, and provides a new solution for the control of thermal power plant SCR system.

Control of Selective Catalytic Reduction Systems Using Feedback Linearisation

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Robust, Model-Based Urea Dosing Control for SCR Aftertreatment Systems using a Cross-Sensitive Tailpipe NOx Sensor

Model-Based Estimation and Control System Development in a Urea-SCR Aftertreatment System

Robust Nonlinear Disturbance Observer Design for Estimation of Ammonia Storage Ratio in Selective Catalytic Reduction Systems

Model Predictive Control: A Unified Approach for Urea-Based SCR Systems

Nonlinear model predictive control applied to multivariable thermal and chemical control of selective catalytic reduction aftertreatment

Closed-Loop Control Strategy and State Estimator for Diesel Engine SCR After-Treatment System

Nonlinear Model Predictive Control of Integrated Diesel Engine and Selective Catalytic Reduction System for Simultaneous Fuel Economy Improvement and Emissions Reduction

Development and verification of model predictive control strategy for selective catalytic reduction with rapid prototyping

Application of an Improved State Feedback Control in the Selective Catalytic Reduction Denitrification Systems of Coal Power Units Under Variable Load Conditions

Model-based Closed-loop Control of Urea SCR Exhaust Aftertreatment System for Diesel Engine

Luenberger-Sliding Mode Observer Based Backstepping Control for the SCR System in a Diesel Engine

Reinforcement-learning-based output-feedback control of nonstrict nonlinear discrete-time systems with application to engine emission control

Prediction and Control of the Nitrogen Oxides Emission for Environmental Protection Goal Based on Data-Driven Model in the SCR De-Nox System

Modelling and control of urea-SCR systems through the triple-step non-linear method in consideration of time-varying parameters and reference dynamics

Adaptive Control of Nonlinear Time-Varying Processes Using Selective Recursive Kernel Learning Method

Model-based urea injection control strategy and ammonia storage estimation for diesel engine SCR system

Black Box SCR Modeling and Control for Small CI Engines

Model-Based Calibration and Control of Tailpipe Nitrogen Oxide Emissions in a Light-Duty Diesel Engine and Its Assessment through Model-In-The-Loop

Adaptive Internal Model Control of SCR Denitration System Based on Multi-Objective Optimization