Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

Study on the Friction Performance of Textured Surface on Water Hydraulic Motor Piston Pair

Experimental Study of Frictional Torque Properties of Plane Port Pairs in Axial Piston Pump

Experimental Analysis On Oil Film Properties Of Plane Port Pair In Axial Piston Machine

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Influence of Different Surface Texture Parameters on the Contact Performance of Piston Ring-Sleeve Friction Pair of Hydraulic Cylinders

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

Study on the Influence of Surface Texture Parameters of Oil Production Screw Motor Rotor on the Tribological Properties of Its Friction Pair

Study on the Thermohydrodynamic Friction Characteristics of Surface-Textured Valve Plate of Axial Piston Pumps

Investigation on Structural Optimization of Anti-Overturning Slipper of Axial Piston Pump

A study on improving friction and wear performance of bearing bush in radial piston hydraulic motor

Experimental Study on Texture Coupling Mechanism and Antifriction Performance of Piston Rod Seal Pair

Research on the Profile Design of Surface Texture in Piston Ring of Internal Combustion Engine

Effect of Surface Texture on Wear Reduction of the Tilting Cylinder and the Valve Plate for a High-Speed Electro-Hydrostatic Actuator Pump

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Experimental Investigation on Friction Characteristics of Ultrasonic Motor

Influence of surface texture parameters of screw pump rotor on tribological properties of its friction pairs

Study on friction performance and mechanism of slipper pair under different paired materials in high-pressure axial piston pump

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Simulation and experimental investigation on low wear rate surface contour of piston/cylinder pair in an axial piston pump

Study on tribological properties of boronized and textured composite surface and its application on camshaft connecting-rod type hydraulic motor

Experimental Research on the Dynamic Lubricating Performance of Slipper/Swash Plate Interface in Axial Piston Pumps