Abstract:Fe- and steelmaking is the largest single industrial CO2 emitter, accounting for 6.5% of all CO2 emissions on the planet. This fact challenges the current technologies to achieve carbon-lean steel production and to align with the requirement of a drastic reduction of 80% in all CO2 emissions by around 2050. Thus, alternative reduction technologies have to be implemented for extracting iron from its ores. The H-based direct reduction has been explored as a sustainable route to mitigate CO2 emissions, where the reduction kinetics of the intermediate oxide product FexO wustite into Fe is the rate-limiting step of the process. The total reaction has an endothermic net energy balance. Reduction based on a H plasma may offer an attractive alternative. Here, we present a study about the reduction of hematite using H plasma. The evolution of both, chemical composition and phase transformations was investigated in several intermediate states. We found that hematite reduction kinetics depends on the balance between the initial input mass and the arc power. For an optimized input mass-arc power ratio, complete reduction was obtained within 15 min of exposure to the H plasma. The wustite reduction is also the rate-limiting step towards complete reduction. Nonetheless, the reduction reaction is exothermic, and its rates are comparable with those found in H-based direct reduction. Chemical and microstructure analysis revealed that the gangue elements partition to the remaining oxide regions, probed by energy dispersive spectroscopy and atom probe tomography. Si-enrichment was observed in the interdendritic fayalite domains, at the wustite/Fe hetero-interfaces and in the primarily solidified oxide particles inside the Fe. With proceeding reduction, however, such elements are gradually removed from the samples so that the final iron product is nearly free of gangue-related impurities.

Synthetic zinc ferrite reduction by means of mixtures containing hydrogen and carbon monoxide

A high-efficiency separation process of Fe and Zn from zinc-bearing dust by direct reduction

Kinetic Analysis of Recovering Zinc from Electric Arc Furnace Dust by Vacuum Carbothermic Reduction at 20 Pa

Zinc Vaporization and Self-reduction Behavior of Industrial Waste Residues for Recycling to the HIsarna Furnace

Mechanisms and kinetics of zinc and iron separation enhanced by calcified carbothermal reduction for electric arc furnace dust

Influence of Different Carbon Content on Reduction of Zinc Oxide via Metal Bath

Recovery of zinc from electric arc furnace dust by vacuum carbothermal reduction

Study on the reduction of Fe2O3 pellets by CO-CO2 and H2-H2O: Reaction kinetics and pore network model

Separation of Zinc from Zinc Ferrite by Magnetization Roasting and Ammonia Leaching

Synergetic Utilization of Zinc-Bearing Dust by Carbothermic Reduction-Roasting Process: Phase Transformation and Morphological Evolution

Thermodynamic Simulation of Metal Reduction from B2O3–CaO–FeO–ZnO Melts by Hydrogen and Carbon Monoxide

Recovery of zinc from zinc oxide dust containing multiple metal elements by carbothermal reduction

The Reduction Reaction Behavior of Steelmaking Dusts with Lignin under Different Atmospheres

Low Carbon and High Efficient Utilization of Zinc-bearing Dust in Iron & Steel Industry by Rotary Kiln Process

Mineral Phase Reconstruction and Separation Behavior of Zinc and Iron from Zinc-Containing Dust

Studies on the Reduction Behavior of Iron Oxide Pellet Fines with Hydrogen Gas: Mechanism and Kinetic Analysis

Thermodynamic and experimental study of high-temperature roasting of blast furnace gas ash for recovery of metallic zinc and iron

Pyrometallurgical Technology for Extracting Iron and Zinc from Electric Arc Furnace Dust

Experimental and Mechanism Research on Vacuum Carbothermal Reduction of Zinc-Containing Electric Arc Furnace Dust

Sustainable steel through hydrogen plasma reduction of iron ore: process, kinetics, microstructure, chemistry

A novel approach for the resource utilization of zinc-bearing dust and sludge via the blast furnace main trough