Abstract:Aluminum foam that is lightweight with high specific strength, high energy absorption and other characteristics can be used in aerospace, transportation, machinery manufacturing and other fields. The PCM method is usually used to prepare closed-cell aluminum foams. The microsized aluminum foams made by this process can solve the non-uniform pore structures caused by liquid drainage during the foaming process of large aluminum foams. The surface morphology and internal pore structure of microsized aluminum foams are affected by the quality of the precursor used for foaming. In this paper, foamable precursors were obtained via either hot rolling or hot extrusion and subsequently foamed. By analyzing the micromorphology and foaming process of the precursor, the influence of the technological method on the macroscopic pore structure of the final aluminum foam was studied. The results show that the aluminum powder particles in the precursor prepared with the hot rolling method had metallurgical bonding, and the outer surface was dense, with almost no porosity and holes in the interior. The microsized aluminum foam obtained after foaming was smooth in appearance, and the internal pore structure was round and uniform. The reason is that during the foaming process of microsize aluminum foam, the foaming agent was evenly distributed in the precursor of the hot rolling process because of its compact structure. During the foaming process, the decomposed gas of the foaming agent will not escape, and the evenly distributed foaming agent tends to nucleate in situ. In the process of rapid foaming, the pressure in the bubble is enough to resist the liquid drainage phenomenon caused by gravity, and the growth direction of the gas core is isotropic, which promotes the foam structure to be more rounded and uniform.

Effect of Orifice Diameter on Bubble Generation Process in Melt Gas Injection to Prepare Aluminum Foams

Effect of Orifice Geometry on Bubble Formation in Melt Gas Injection to Prepare Aluminum Foams

Bubble Formation at a Submerged Orifice for Aluminum Foams Produced by Gas Injection Method

Effect of Gas Chamber Volume and Number of Orifices on Pore Size in Gas Injection Foaming Process

Factors Influencing Foam Height in Gas Injection Process for Aluminum Foams

Bubble Formation at a Submerged Orifice in High-Speed Horizontal Oscillation

On the Size Effects in Micro/meso Semisolid Extrusion–forging of A356 Aluminum Alloy

Effect of Contact Angle on Bubble Formation at Submerged Orifices

Study on an Aluminum Foam by Gas Injection Foaming

Influence of Gas Pressure and Blowing Agent Content on the Formation of Aluminum Alloy Foam

Preparation of Aluminum Foam by Gas Injection Foaming

Dynamics of bubbles detached from non-circular orifices: Confinement effect of orifice boundary

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Properties of Aluminum Foam Prepared by Gas Injection Method

Foam Stability in Gas Injection Foaming Process

Oxidation Kinetics of Oxide Film on Bubble Surface of Aluminum Foams Produced by Gas Injection Foaming Process

A Computational Study of Bubble Formation from an Orifice Submerged in Liquid with Constant Gas Flow

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Effect of Ca on Particulate Dispersion and Foam Stability in Gas Injection Foaming Process

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method