A Computational Study of Bubble Formation from an Orifice Submerged in Liquid with Constant Gas Flow

James Q. Feng

2024-06-18

Abstract:The process of bubble formation from an orifice submerged in liquid with constant gas flow is studied by numerical simulations using an OpenFOAM volume-of-fluid solver named interIsoFoam. The computed results show that the detached bubble size tends to increase with the gas flow rate, orifice size, surface tension, liquid contact angle, etc. in qualitative agreement with most previous authors. For a given orifice size and liquid properties, there exists a critical gas flow rate above which detached bubbles will combine via coalescence known as bubble pairing. The detached bubble size seems insensitive to the contact angle when the liquid adequately wets the orifice wall, but can increase substantially if the contact angle is increased beyond a critical value resulting in contact line motion on the horizontal orifice surface. The value of such a critical contact angle increases with the orifice size as well as gas flow rate. Such revelations would logically suggest that the usage of reduced orifice size for generating smaller bubbles could be more challenging and practically difficult with constant gas flow for sub-millimeter orifices.

Fluid Dynamics

What problem does this paper attempt to address?

This paper aims to study the process of bubble formation when gas passes through an orifice immersed in a liquid at a constant flow rate. Specifically, the author used the OpenFOAM® Volume - of - Fluid (VOF) solver interIsoFoam for numerical simulation to explore how bubble size is affected by factors such as gas flow rate, orifice size, surface tension, and liquid contact angle. In addition, the paper also pays special attention to the fact that, given the orifice size and liquid properties, there is a critical gas flow rate, and beyond this flow rate, the detached bubbles will grow larger through coalescence (i.e., bubble pairing). The paper also discusses the insensitivity of bubble size to the contact angle when the liquid fully wets the orifice wall, and the significant impact of the movement of the contact line on the horizontal orifice surface on bubble size when the contact angle exceeds a certain critical value. These findings are of great significance for practical applications of generating smaller bubbles, especially for the challenges faced when using a constant gas flow rate and sub - millimeter orifices.