Abstract:Top-gate self-aligned structured oxide thin-film transistors (TFTs) are suitable for the backplanes of high-end displays because of their low parasitic capacitances. The gate insulator (GI) deposition process should be carefully designed to manufacture a highly stable, high-mobility oxide TFT, particularly for a top-gate structure. In this study, a nanometer-thick Al2O3 layer via plasma-enhanced atomic layer deposition (PE-ALD) is deposited on the top-gate bottom-contact structured oxide TFT as the interface tailoring layer, which can also act as the hydrogen barrier to modulate carrier generation from hydrogen incorporation into the active layer of the TFT during the following process such as postannealing. Al-doped InSnZnO (Al/ITZO) with an Al/In/Sn/Zn atomic ratio composition of 1.7:24.3:40:34 was used for high mobility oxide semiconductors, and an Al2O3/Si3N4 bilayer was used for the GI. The degradation issue due to the excellent barrier characteristics of Al2O3 and Si3N4 can be minimized. An oxide TFT fabricated without the interface tailoring layer exhibits conductor-like characteristics owing to the excessive carrier generation by hydrogen incorporation. However, TFTs with additional interface layers exhibit reasonable characteristics and distinct trends in electrical characteristics depending on the thicknesses of the interface layers. The optimized devices exhibit an average turn-on voltage (Von) of -0.31 V with 33.63 cm2/(V s) of high mobility and 0.09 V/dec of subthreshold swing value. The interfaces between the active layer and hydrogen barriers were investigated using a high-resolution transmission electron microscope, contact angle measurement, and secondary ion mass spectroscopy to reveal the origin of the trends in properties between the devices. The top-gate device with a hydrogen barrier using the four-cycle deposition exhibits optimum electrical characteristics of both high mobility and good stability with only a 0.04 V shift of Von under positive-bias temperature stress (PBTS). We realize a high-end, self-aligned TFT with high mobility [34.7 cm2/(V s)] and negligible Von shift of -0.06 V under PBTS by applying a subnanometer hydrogen barrier.

Large‐area, high‐temperature stainless steel foil substrate for manufacturing low‐cost and flexible CMOS polysilicon TFTs

Floating Low-Temperature Radio-Frequency Plasma Oxidation of Polycrystalline Silicon-Germanium

Low-temperature and low thermal budget fabrication of polycrystalline silicon thin-film transistors

Single-crystalline silicon nanomembrane thin-film transistors with anodized aluminum oxide as a gate dielectric on rigid and flexible substrates

A Low Temperature Polycrystalline Si TFT Technology for Large area AMLCD Drivers

Low Temperature Poly-Si TFT Technology

High Performance Transparent In-Plane Silicon Nanowire Fin-Tfts Via A Robust Nano-Droplet-Scanning Crystallization Dynamics

Oxide TFTs with S/D-contacts patterned by high-resolution reverse-offset printed resist layers

50‐4: Invited Paper: Low‐Temperature Metal‐Oxide Thin‐Film Transistor Technology and the Realization of Electronic Systems on Flexible Substrates

Flexible Hybrid Single-Crystalline Silicon Nanomembrane Thin-Film Transistor with Organic Polymeric Polystyrene as a Gate Dielectric on a Plastic Substrate

Self-Aligned Top-Gate Metal-Oxide Thin-Film Transistors Using a Solution-Processed Polymer Gate Dielectric

Multi-project wafers for flexible thin-film electronics by independent foundries

Engineering a Subnanometer Interface Tailoring Layer for Precise Hydrogen Incorporation and Defect Passivation for High-End Oxide Thin-Film Transistors

High‐performance Nd: AIZO/Al2O3 dual active layer design without thermal annealing: high‐speed electron transport and defect modification in thin film transistors

Implementing Room‐Temperature Fabrication of Flexible Amorphous Sn–Si–O TFTs via Defect Control

P‐40: TFT‐LCD a‐Si Wet Etch Technology

Supercritical Ammoniation-Enabled Interfacial Polarization for Function-Mode Transformation and Overall Optimization of Thin-Film Transistors

High-performance a-IGZO-based flexible TTFT with stacked dielectric layers via ultrathin high-κ SrTiO3 buffer layer grown on HfO2

Teflon/SiO2 Bilayer Passivation for Improving the Electrical Reliability of Oxide TFTs Fabricated Using a New Two-Photomask Self-Alignment Process

High-Yield, Scaling-Up Fabrication of Fermi-Level-Pinning-Free Organic Thin-Film Transistor Arrays with Printed Van der Waals Contacts

Flexible IGZO Thin-Film Transistors and Inverter Circuits with Diode-Connected Transistors Fabricated on Transparent Polyimide Substrates