Abstract:Abstract Vortex Shedding at pipe junctions can create pressure pulsations and flow-induced vibrations. The flow through one pipe may result in a shear layer at the junction with a second pipe. Instabilities such as vortex shedding in the shear layer can then excite acoustic modes in the second pipe, especially when the flow in the secondary pipe is stagnant or weak. The effect is the excitation of a pipe organ mode, which under certain conditions, may result in unacceptable noise and/or vibration levels. Within the nuclear industry this phenomenon has been most frequently observed in boiling water reactors (BWRs), resulting in vortex-induced, main steam line associated stand pipe acoustic resonances. This phenomenon has not been typically observed in pressurized water reactors (PWRs), especially in primary coolant loops due to the lengths of pipe needed to support acoustic resonances in water systems relevant to driving lower order structural piping modes. However, if certain conditions exist, PWRs do contain large sections of piping which can be susceptible to such flow-induced adverse noise and vibration effects. This paper describes the evaluation and mitigation of structural vibrations due to a vortex-induced excitation of an acoustic mode of a large side branch pipe in a high-energy, water-filled, PWR piping system. Specifically, an acoustic resonance was observed and structurally significant resultant vibration levels were measured on a safety related piping system directly connected to a PWR primary reactor coolant system (RCS) between the reactor and a steam generator. A rapidly employed evaluation program was implemented, which included significant in-situ structural vibration measurements that informed a combination of acoustic, structural, and fluid-domain numerical modeling evaluations. These evaluations were performed in concert to provide both root cause insights and candidate mitigation strategies. Candidate mitigation strategies were then evaluated prior to inplant implementation via further modeling evaluations and a model-scale testing program. This paper describes the primary vibration characteristics of interest of the affected piping system, the data analyses and modeling methods used to successfully identify the vibro-acoustic phenomena, the developed mitigation strategies, and verification of the final mitigation strategy via model-scale with final demonstration occurring in the plant prior to fuel load.

Study on Vibration Deadening of Double Pipe-Filled Bead for Primary Piping System in Fast Breeder Reactor

Experimental and Numerical Investigation on the Seismic Behavior of above Ground High Density Polyethylene Pipe in Nuclear Power Plant

Impact of Inelastic Seismic Design Using Elastic–Plastic Pipe Supports on Vibration Response of Piping Systems

Failure Behavior Analyses of Piping System under Dynamic Seismic Loading

Analysis and Controlling of Pipeline Vibration in Chemical Plant

Study on the effect of corrosion defects on VIV behavior of marine pipe using a new defective pipe element

INVESTIGATION ON DAMAGE EVALUATION INDEX WITH DUCTILITY FACTOR BASED ON SIMULATION ANALYSIS FOR LOADING TEST OF PIPING SUPPORT STRUCTURE

Vibration of a High Energy PWR Piping System due to Vibro-Acoustic Coupling: Evaluation and Mitigation

HYBRID DYNAMIC RESPONSE TEST FOCUSING ON THE SUPPORT STRUCTURE OF PIPING SYSTEMS

Failure Probability Analysis of Aged Piping Using Probabilistic Fracture Mechanics Methodology Considering Seismic Loads

Failure Probability Of Degraded Pipes Based On Probabilistic Fracture Mechanics For Seismic Safety Margin Assessment On Npp

Evaluation of the Seismic Performance of Butt-Fusion Joint in Large Diameter Polyethylene Pipelines by Full-Scale Shaking Table Test

Development of Seismic Response Analysis Method of Piping System: Proposal of the Nonlinear Spring Model for Piping Support Structures

Subcooled boiling-induced vibration of a single heater rod confined with metallic walls

Benchmark analysis and numerical investigation on probabilistic fracture mechanics analysis codes for NPPs piping

DEVELOPMENT OF GUIDELINE ON SEISMIC FRAGILITY EVALUATION FOR AGED PIPING

BEHAVIOR OF VAPOR BUBBLES GENERATED ON A SINGLE HEATER ROD PARTLY CONFINED BY METALLIC WALLS IN SUBCOOLED WATER

Pipe vibration attenuation through internal damping and optimal design of vibro-impact systems

Vibration suppression of pipe system with tuned mass damper

OS1427 Evaluation Method of Crack Growth in Reactor Piping Subjected to Seismic Loading Beyond Small Scale Yielding Condition

Vibration and Damping Analysis of Pipeline System Based on Partially Piezoelectric Active Constrained Layer Damping Treatment