Abstract:Fabrication of nano-crystalline thin film solar cell by co-sputtering of silicon and aluminum, and metal induced crystallization is reported in this paper. After a brief introduction on magnetron sputtering and aluminum induced crystallization techniques, it discusses the drawbacks of "aluminum induced layer exchange" concept as the common method for fabricating poly-Si thin films; and proposes Si-Al co-sputtering as a simple alternative fabrication method. Then a three-steps process is introduced for the fabrication of "Al electrode/n-Si wafer/p-Si thin film/Al electrode" solar cell. Material and electrical characterizations of the fabricated p-Si thin films are done by Raman spectroscopy, X-ray diffraction, optical microscopy, scanning electron microscopy and Hall Effect measurement to study the crystallization ratio, grain size, morphology, carrier density and mobility of the prepared films, respectively. The best fabricated samples show a crystallization ratio of 88% and the largest grain size of 68 nm. The hole concentration in the films is in the order of 10(18) to 10(19) cm(-1) with a maximum mobility value of 17 cm(2)/V s. Then, photovoltaic properties of the fabricated solar cells are determined by under dark and illumination J-V curves, and external quantum efficiency measurements. Dark J-V curve of the best sample represents an ideality factor of 1.39, rectification ratio of 1993 at 1 V and reverse saturation current density of 62.1 nA/cm(2) which confirms the formation of a good p-n junction. The illuminated J-V curve under AM1.5G conditions exhibits a photovoltaic conversion efficiency of 6.02% for the best sample, with a short circuit current density of 24.9 mA/cm(2) and open circuit voltage of 456 mV. The external quantum efficiency of this sample reaches to more than 59% at the wavelength of 700 nm. Finally, a simple model is proposed to describe the formation of nano-crystalline Si thin film, deposited by Si-Al co-sputtering, during the thermal annealing.

Properties of Aluminium Thin Films on Polyethylene Terephthalate Substrates as Back Contacts in Thin Film Silicon Solar Cells

Study on Annealing Process of Aluminum Oxide Passivation Layer for PERC Solar Cells

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Influence of Deposition Substrate Temperature on the Morphology and Molecular Orientation of Chloroaluminum Phthalocyanine Films As Well the Performance of Organic Photovoltaic Cells

Light Scattering by Textured Al-Doped Zinc Oxide Film for Thin Film Silicon Solar Cells Coated on Glass Substrates

PHYSICAL PROPERTIES OF WEDGE-SHAPED Al THIN FILM

Efficiency improvement of PERC solar cell using an aluminum oxide passivation layer prepared via spatial atomic layer deposition and post-annealing

Effect of film thickness on properties of aluminum doped zinc oxide thin films deposition on polymer substrate

An additive manufacturing approach based on electrohydrodynamic printing to fabricate P3HT:PCBM thin films

Amorphous silicon thin‐film solar cells deposited on flexible substrates using different zinc oxide layers

Impacts of the Annealing Profile on AIC Thin Film Solar Cell Characteristics Fabricated by Magnetron Sputtering

Facile Synthesis and Characterization of PbS thin films doped with various Aluminum Concentrations for Photovoltaic Applications

Quantitative Nanoscale Monitoring the Effect of Annealing Process on the Morphology and Optical Properties of Poly(3-Hexylthiophene)/[6,6]-phenyl C61-butyric Acid Methyl Ester Thin Film Used in Photovoltaic Devices

Annealing Of P3ht:Pcbm Blend Film-The Effect On Its Optical Properties

Influence of thermal annealing on microstructure, energetic landscape and device performance of P3HT: PCBM-based organic solar cells

Preparation and Properties of Different Dielectric Films with Al Metal Electrode

Evaluation Of Mechanical Properties Of Polycrystalline Al Thin Films On 7059 Glass Substrates

Characterization of Surface Morphology and Light Scattering of Transparent Conducting ZnO:Al Films as Front Electrode for Silicon Thin Film Solar Cells

Thermal resistance of ceramic films on aluminum alloy by PECC

Nano-crystalline Thin Films Fabricated by Si-Al Co-Sputtering and Metal Induced Crystallization for Photovoltaic Applications

Effect of the annealing temperature on the refractive index and extinction coefficient of aluminum-doped zinc oxide: a low-cost electron transport layer