Abstract:Microcrystalline silicon, which is widely used in the microelectronics industry, is usually fabricated by chemical vapor deposition techniques. In recent years, magnetron sputtering has been considered as an alternative because it is a simpler, cheaper and more eco-friendly technique. The big drawback of this technique, however, is the need to recrystallize the as-deposited amorphous silicon, which can be done by metal-induced crystallization. Among the different suitable metals, copper has not been extensively investigated for this purpose. Furthermore, the applicability of the microcrystalline film prepared by this method has not been evaluated for photovoltaic device fabrication. Therefore, this paper reports the fabrication of p-type microcrystalline silicon thin film by magnetron sputtering and copper-induced crystallization techniques, and evaluates its appropriateness for solar cell fabrication. In the first step, 60 nm of silicon followed by 10 nm of copper were deposited on n-type silicon wafer and glass substrates, both by the magnetron sputtering technique. Then, the as-deposited samples were annealed at temperatures from 450 °C to 950 °C. The crystal properties of the resulting films were characterized by Raman and X-ray diffraction spectroscopies and optical and secondary emission microscopies, while their electrical characteristics were determined by Hall-effect, J-V curve and external quantum efficiency measurements. These characterizations confirmed the formation of a layer of microcrystalline silicon mostly in the <111> direction with a crystallization ratio of 93% and a largest grain size of 20 nm. The hole concentration and mobility of the fabricated p-type microcrystalline silicon layer were about 1017~1019 cm−3 and 8 cm2/V.s, respectively. By using the fabricated film as the emitter layer of a p-n junction solar cell, a good rectification ratio of 4100 and reverse saturation current density of 85 nA.cm−2 were measured under dark conditions. The highest photovoltaic conversion efficiency, i.e., 2.6%, with an open-circuit voltage of 440 mV and short-circuit current density of 16.7 mA/cm2, were measured under AM1.5G irradiance. These results indicate that microcrystalline silicon created by magnetron sputtering and copper-induced crystallization has considerable potential for photovoltaic device fabrication.

Impacts of the Annealing Profile on AIC Thin Film Solar Cell Characteristics Fabricated by Magnetron Sputtering

Modulation of Interfacial and Electrical Properties of ALD-derived HfAlO/Al2O3/Si Gate Stack by Annealing Temperature

Influence of annealing on microstructures and photoluminescence of nano-composite silicon film

Nano-crystalline Thin Films Fabricated by Si-Al Co-Sputtering and Metal Induced Crystallization for Photovoltaic Applications

Novel Sandwich Structure for Aluminum Induced Crystallization of Amorphous Silicon Thin Films at Low Temperature

Post-Fabrication Annealing Effects in Polymer-Nanotube Photovoltaic Cells

Effect of annealing on microstructure and photoluminescence of nano-composite silicon film

P-silicon Thin Film Fabricated by Magnetron Sputtering and Aluminium Induced Crystallization for Schottky Silicon Solar Cells

Annealing effects of In2O3 thin films on electrical properties and application in thin film transistors

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Effects of Annealing on CuInGaSe2 Solar Cell Prepared by Magnetron Sputtering

Post annealing to improve the sheet resistance and uniformity of emitter for enhancing conversion efficiency of mass-produced mc-Si solar cells

Optimization of Material Structure of Ploy-Si Thin Film Based on Al Induced Crystallization

Annealing effects on properties of antimony tin oxide thin films deposited by RF reactive magnetron sputtering

Investigation of Microcrystalline Silicon Thin Film Fabricated by Magnetron Sputtering and Copper-Induced Crystallization for Photovoltaic Applications

Quantitative Nanoscale Monitoring the Effect of Annealing Process on the Morphology and Optical Properties of Poly(3-Hexylthiophene)/[6,6]-phenyl C61-butyric Acid Methyl Ester Thin Film Used in Photovoltaic Devices

Optical Properties of Nanocrystal-Silicon Thin Films on Silicon Nanopillar Arrays after Thermal Annealing

On the influence of annealing on the compositional and crystallographic properties of sputtered Li-Al-O thin films

Annealing Effect on Optical and Electronic Properties of Silicon Rich Amorphous Silicon-Carbide Films

Structural and Electrical Properties of Polysilicon Films Prepared by AIC Process for a Polycrystalline Silicon Solar Cell Seed Layer

Metal Nano-Particles Sizing by Thermal Annealing for the Enhancement of Surface Plasmon Effects in Thin-Film Solar Cells Application