Abstract:Ceramic coatings on 6063 aluminum alloy were prepared by plasma electrolytic oxidation (PEO) using pulsed bipolar power supply under different anodic and cathodic current densities. The scanning electron microscope (SEM), x-ray diffraction (XRD), potentiodynamic polarization curves analysis and tribometer were used to investigate the microstructure, phase composition, corrosion and wear resistance properties of PEO coatings. It is found that with the anodic and cathodic current densities increasing, the whole layer thickness increased while the rate of inner compact layer increased and then decreased. The proportion of α-Al2O3 phase in PEO coatings increased when anodic current density increased. However, higher cathodic current density would result in less α-Al2O3 phase in the coating. All these phenomena can be explained by the effects of anodic and cathodic current on PEO process. Higher anodic current density would enhance the discharge reaction and generate more heat and higher temperature, which are the essential conditions for γ-Al2O3 phase transforming to α-Al2O3 phase. But it also damages the ceramic coatings, causing large voids and microcracks in PEO coatings. Certain level of cathodic current can drive Al3+ losing in the electrolyte back to the oxide-electrolyte interface and inhibit the large size sparks, which favors the growth of ceramic coatings. However, too high cathodic current would inhibit the anodic process and heat generation, so that the rate of compact layer and proportion of α-Al2O3 phase decrease. Furthermore, higher rate of compact layer and larger proportion of α-Al2O3 phase in the ceramic coatings significantly improve the corrosion and wear resistances. It is possible to obtain the desired structure, composition and properties of PEO coatings by controlling anodic and cathodic current densities.

Thermal resistance of ceramic films on aluminum alloy by PECC

Thermal barrier effect from internal pore channels on thickened aluminum nanofilm

Investigation of the thermal conductivity of diamond film on aluminum nitride ceramic

Effect of Aluminum on Thermal Performance of Ceramsite and Its Application

Effect of Electrical Modes on Dielectric and Insulation Properties of Plasma Electrolytic Oxidation Ceramic Films on Al

Thermal Conductivity of Anodic Alumina Film at (220 to 480) K by Laser Flash Technique

Study of Low-Temperature Thermal Shock Resistance of Plasma-Arc Sprayed Alumina Ceramic Coating

Properties of Aluminium Thin Films on Polyethylene Terephthalate Substrates as Back Contacts in Thin Film Silicon Solar Cells

The Study of Structure and Performance of Ceramic Coating on Aluminum Alloy by Plasma Microarc Oxidation

Effects of Electric Parameters on Structure and Thermal Control Property of Peo Ceramic Coatings on Ti Alloys

The Influence of High- Al2O3 on the Thermal Conductivity of EVA Film

Effects of Anodic and Cathodic Current Densities on Microstructure, Phase Composition and Properties of Plasma Electrolytic Oxidation Ceramic Coatings on 6063 Aluminum Alloy

Anti‐reflection property and corrosion resistance of black ceramic superhydrophobic coatings on aluminum alloy

Preparation of High Emissivity and Low Absorbance Thermal Control Coatings on Ti Alloys by Plasma Electrolytic Oxidation

Influence of Alumina Content and Thermal Treatment on the Thermal Conductivity of UPE/Al2O3 Composite

Carbon/Aluminum Composites with High Thermal Conductivity for Thermal Management Applications

Study of the Mechanical Properties and Thermal Control Performance of Plasma-Sprayed Alumina Coating on Aluminum Alloy Surface

Tribological Behavior of Cathode Plasma Electrolytic Deposited Al2Y4O9 Coating on Aluminum Alloy

Effect of thermal conductivity on micro-arc oxidation coatings

On the thermal expansion coefficients of thin films

Preparation of thermal control coatings on Ti alloy by plasma electrolytic oxidation in K 2 ZrF 6 solution