Abstract:Nanostructured and conventional alumina–3 wt.% titania monolithic coatings were deposited by air plasma spraying (APS). The thermal diffusivity was measured by the laser flash technique. The thermal diffusivity of the nanostructured Al2O3–3 wt.% TiO2 coating was higher compared with that of the corresponding conventional coating at temperature ranging from 200 to 1000 °C. For the nanostructured coating, there was no difference in the thermal diffusivity between during heating and cooling. However, the thermal diffusivities of the conventional coating were higher during cooling than those during heating. SEM and TEM examination showed that the nanostructured coating contained equiaxed grains with sizes from 150 to 800 nm besides splat lamellae. In the nanostructured coating, most of columnar grains in splat lamellae were less than 200 nm. Splat lamellae of the nanostructured coating bonded well each other and their thickness ranged from 0.4 to 1 μm. The decrease of thermal diffusivity of the nanostructured coating was attributed to the increase of grain boundaries and defective crystal structure. The stability of thermal diffusivity of the nanostructured coating was considered to relate to the absence of narrow long micro-cracks between splat lamellae. Nanostructured and conventional alumina–3 wt.% titania monolithic coatings were deposited by air plasma spraying (APS). The thermal diffusivity was measured by the laser flash technique. The thermal diffusivity of the nanostructured Al2O3–3 wt.% TiO2 coating was higher compared with that of the corresponding conventional coating at temperature ranging from 200 to 1000 °C. For the nanostructured coating, there was no difference in the thermal diffusivity between during heating and cooling. However, the thermal diffusivities of the conventional coating were higher during cooling than those during heating. SEM and TEM examination showed that the nanostructured coating contained equiaxed grains with sizes from 150 to 800 nm besides splat lamellae. In the nanostructured coating, most of columnar grains in splat lamellae were less than 200 nm. Splat lamellae of the nanostructured coating bonded well each other and their thickness ranged from 0.4 to 1 μm. The decrease of thermal diffusivity of the nanostructured coating was attributed to the increase of grain boundaries and defective crystal structure. The stability of thermal diffusivity of the nanostructured coating was considered to relate to the absence of narrow long micro-cracks between splat lamellae.

Study of the Mechanical Properties and Thermal Control Performance of Plasma-Sprayed Alumina Coating on Aluminum Alloy Surface

Fabrication and Evaluation of Plasma Sprayed Nanostructured Alumina–titania Coatings with Superior Properties

Thermal diffusivity of plasma sprayed monolithic coating of alumina–3 wt.% titania produced with nanostructured powder

Characterization of Alumina–3 Wt.% Titania Coating Prepared by Plasma Spraying of Nanostructured Powders

Corrosion Behavior and Thermal Conductivity of Plasma Sprayed AlN / Al 2 O 3 Coating

Effect of High-Temperature Thermal Shock on Solar Absorption Rate of Alumina Coating

D. C. Plasma-Sprayed Coatings of Nanostructured Alumina-Titania-Silica

Effect of high-enthalpy atmospheric plasma spraying parameters on the mechanical and wear resistant properties of alumina ceramic coatings

Influence of Original Powders on the Microstructure and Properties of Thermal Barrier Coatings Deposited by Supersonic Atmospheric Plasma Spraying, Part Ii: Properties

Preparation and Properties of Thermal Barrier Coating with Nanometer Alumina Coated Zirconia

Mechanical, Tribological, and Oxidation Resistance Properties of NiCrAlY Coating by Atmospheric Plasma Spraying

Microstructure of alumina–3wt.% titania coatings by plasma spraying with nanostructured powders

Study of Low-Temperature Thermal Shock Resistance of Plasma-Arc Sprayed Alumina Ceramic Coating

Mechanical Properties and Thermal Shock Resistance of HVOF Sprayed NiCrAlY Coatings Without and with Nano Ceria

Microstructure and Properties of Multi-Function Micro-Plasma Sprayed Al2o3 Coatings

Microstructure and Wear Behaviors of Plasma-Sprayed MoAlB Ceramic Coating

Effect of Spraying Parameters on the Microstructure and Mechanical Properties of Micro-Plasma Sprayed Alumina-Titania Coatings

Effect of nano‐Al 2 O 3 on the microstructure and properties of NbB 2 ‐NbC composite coatings prepared by plasma spraying

The Influence of the Oxidation Time on the Optical Properties of the Ceramic Thermal Control Coating Prepared by Micro-Plasma Oxidation

Structure and performance of γ-alumina washcoat deposited by plasma spraying