Abstract:A primary mode of failure of thin-film coatings is the mismatch in thermal expansion coefficients of the substrate and the coating, which results in accumulation of interfacial stresses and ultimately in film delamination. While much attention has been devoted to modulation of interfacial bonding to mitigate delamination, current strategies are constrained in their generalizability and have had limited success in imbuing resistance to prolonged thermal cycling. We demonstrate here the incorporation of rigid thermal expansion compensators within polymeric films as a generalizable strategy for minimizing thermal mismatch with the substrate. Nanostructures of the isotropic negative thermal expansion (NTE) material HfV2O7 have been prepared based on the reaction of nanoparticulate precursors. The NTE behavior, derived from transverse oxygen displacement within the cubic structure, has been examined using temperature-variant powder X-ray diffraction, Raman spectroscopy, electron microscopy, and selected-area electron diffraction measurements. HfV2O7 initially crystallizes in a 3 × 3 × 3 superlattice but undergoes phase transformations to stabilize a cubic structure that exhibits strong and isotropic NTE with a coefficient of thermal expansion (CTE) = −6.7 × 10–6 °C–1 across an extended temperature range of 130–700 °C. Incorporation of HfV2O7 in a high-temperature thermoset polybenzimidazole enables the reduction of compressive stress by 67.3% for a relatively small loading of 26.6 vol % HfV2O7. Based on a composite model, we demonstrate that HfV2O7 can reduce the thermal expansion coefficient of polymer nanocomposite films, even at low volume fractions, as a result of its substantially higher elastic modulus compared to the continuous polymer matrix. By changing the volume fraction of HfV2O7, the overall coefficients of thermal expansion of the film can be tuned to match a range of substrates, thereby mitigating thermal stresses and resolving a fundamental challenge for high-temperature composites and nanocomposite coatings.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c10867.SEM-EDS mapping analysis on HfO2/VO2 ball-milled mixtures; XRD pattern of HfV2O7 synthesized from different HfO2; X-ray diffraction patterns of HfV2O7 synthesized from conventional solid-state method; Rietveld refinement of the HfV2O7 structure; and XRD patterns of HfV2O7 collected at 30, 50, 100, 150, and 200 °C (PDF)This article has not yet been cited by other publications.

Negative thermal expansion in a zirconium tungstate/epoxy composite at low temperatures

Near-zero thermal expansion of ZrW2O8/Al–Si composites with three dimensional interpenetrating network structure

Negative thermal expansion in α-Zr2SP2O12 based on phase transition- and framework-type mechanisms

ZrW2O8 with Negative Thermal Expansion Fabricated at Ultralow Temperature: an Energy-Efficient Strategy for Metastable Material Fabrication

Preparation of Negative Thermal Expansion ZrW2O8 Powders and Its Application in Polyimide/ZrW2O8 Composites

ZrW2O8/ZrO2 Composites with Low/Near-Zero Coefficients of Thermal Expansion Fabricated at Ultralow Temperature: an Integration of Hydrothermal Assembly and a Cold Sintering Process

Properties of polyphenylene sulphide/glass fibre composites with negative thermal expansion ceramic fillers

Lightweight and near-zero thermal expansion ZrW2O8-SiCnw/Al hybrid composites

Investigation of the Negative Thermal Expansion of ZrW2O8

Preparation and negative thermal expansion in medium-entropy ceramics (Zr1/3Hf1/3Ti1/3)V2O7

Ultra‐low loss polyphenylene oxide‐based composites with negative thermal expansion fillers

Effect of Yb Substitution on Microstructure, Physical and Mechanical Properties of Negative Thermal Expansion Zr1−xYbxWMoO8−x/2 (x = 0–0.05) Ceramic

Effects of the Liquid Phase Content on the Microstructure and Properties of the ZrW2O8 Ceramics with Negative Thermal Expansion Fabricated by the Cold Sintering Process

Macro-Scale Strength And Microstructure Of Zrw2o8 Cementitious Composites With Tunable Low Thermal Expansion

Zr 1− X Yb X WMoO 8− X /2 ( X = 0, 0.04) Ceramics Fabricated by in Situ Synthesis from Trigonal Polymorph: Preparation, Sintering Process, and Negative Thermal Expansion Properties

The effect of carbon fiber length on the thermal expansion of fiber‐reinforced particulate hybrid composites

Tuning Epoxy Thermomechanics via Thermal Isomerization: A Route to Negative Coefficient of Thermal Expansion Materials.

Abnormal Thermal Expansion Coefficients in (nd1−xdyx)2zr2o7pyrochlore: the Effect of Low-Lying Optical Phonons

Novel low temperature derived W f /W-ZrC-Cu composites by reactive infiltration with enhanced mechanical and thermal physical properties

Negative Thermal Expansion HfV 2 O 7 Nanostructures for Alleviation of Thermal Stress in Nanocomposite Coatings

Dielectric Properties and Thermal Expansion of ZrW2 O8 /polyimide Hybrid Films