Abstract:Copper oxide was synthesis by hydrothermal method using copper nano powder (30nm) and deionized water on quartz substrate. At temperature 100 °C, different experimental time ranging from (24–72 h). Different copper oxide phase was presented in X-Ray diffraction analyzer, the crystal size increased as the reaction time increased as it calculated using scherrer equation to be (21.1–32.03 nm), and Williamson Hall plot to be (40.3–87.7 nm). Also, Raman spectroscopy show different copper phase and the highest intensity peak at 220 cm −1 , due to the cuprous oxide in all sample used to distinct chemical fingerprint for a particular molecule or material. Many of metal oxide bond was study by FTIR to clarify the compositional and chemical properties of the prepared samples. Optical characteristic with different absorption peaks of thin film show decrease in the band gap from (2.8–2.4 eV) as the reaction time increase. PL measurement used also to determine the band gap energy of the prepared thin film which found to be agreement with UV–Vis, and the band gap value is (2.7, 2.6, 2.5, 2.3, and 2.3 eV), respectively. Increasing in the surface roughness from (3.637–25.16 nm), and in the root mean square from (5–29.39 nm), and grain size with increasing the reaction time from (24–72 h), respectively, was measured by using AFM technique. Different morphologies were showed with increasing the reaction time, spherical and truncated octahedral in different type was obtained by field emission-scanning electron microscope (FE-SEM) as the particles subject to transformation caused the preparing agglomerated crystallites. The electrical characteristic was analysis use DC measurement to measure the activation energy which varied with reaction time. The figure of merit analysis shows that the copper oxidation state to obtain cuprous oxide (Cu 2 O) is mainly obtained at the 48 h-reaction time. The used of copper nano powder in hydrothermal method without adding any auxiliary material the main aim of this research.

Preparation and Characterization of Copper Oxide Nanoparticles Through Solid State Thermal Decomposition of an Aqua Nitrato Copper(II) Complex with a Tridentate Schiff-base Ligand as a New Precursor

The Convenient Preparation of Porous CuO Via Copper Oxalate Precursor

In situ thermal decomposition route: Preparation and characterization of nano nickel, cobalt, and copper oxides using an aromatic amine complexes as a low-cost simple precursor

The effect of ultrasonic irradiation power and initial concentration on the particle size of nano copper(II) coordination polymer: Precursors for preparation of CuO nanostructures

Synthesis and Characterization of Copper Oxide Nanoparticles by Solution Evaporation Method

Preparation and Characterization of CuO Nanorods by Thermal Decomposition of CuC2O4 Precursor

Solvent-Free Method for Nanoparticles Synthesis by Solid-State Combustion Using Tetra(Imidazole)Copper(II) Nitrate

Preparation And Characterization Of Copper-Based Nanoparticles As Catalyst For Ammonium Perchlorate(Ap)

Deposition time effect on copper oxide nano structures, an analysis study using chemical method

Synthesis and the Thermal Decomposition Reaction of Copper(II) Oxamide Complexes

Study on Preparation of Copper Oxide Nanopowders

Preparation and characterization of porous copper powder by thermal decomp osition of complicated copper oxalate

Temperature and time dependent morphological evolution of solution phase synthesized copper oxide nanostructures

Preparation, characterization and catalytic property of CuO nano/microspheres via thermal decomposition of cathode-plasma generating Cu2(OH)3NO3 nano/microspheres.

Facile Synthesis of Copper(I) Oxide Nanochains and the Photo-Thermal Conversion Performance of Its Nanofluids

Synthesis and characterization of complicated copper oxalate precursor powder by complexing precipitation method

Preparation of Nano-CuO by thermal decomposition of Cu(OH)2

Solid state synthesis of Liquorice‐stabilized copper‐based nanoparticles: structural and catalytic studies

Preparation and Characterization of CuO Nanoparticles with Different Size and Morphology

Preparation of Needle-shaped CuO Nanocrystals and Its Catalytic Properties

Preparation of Copper Nanoparticles by Radiation