Abstract:Megapores with spherical-like cells connected through windows and high porosities make up catalyst supports in the form of ceramic foams. These characteristics provide significant benefits for catalytic processes that are limited by mass or heat transport. This study focuses on the manufacture of ceramic foam using a polymeric sponge replica process and polymer foams as a template for catalyst supports, which are industrial waste from the packaging sector. To make ceramic foam catalysts, they were dipped in a catalyst solution, followed by a breakdown stage and a sintering process. Experiments focused on determinants that affect the desired characteristics of ceramic foams, such as the types of polymer foams that affect foam morphology, the rheology of catalyst solution that affects catalyst dispersion, and the polymer decomposition rate that affects catalytic performance during dry reforming of the methane process. The cell architectures of polyurethane and polyvinyl alcohol foams are attractive for catalyst support preparation because they have 98-99% porosity and typical cell sizes of 200 and 50 μm, respectively. The polyurethane performance was superior to the performance of polyvinyl alcohol in terms of higher porosity and better catalytic-solution absorption offering high catalyst active areas. The catalyst prepared from concentrated 10 wt % Ni/Al2O3-MgO (10NAM) slurry had the highest surface area (59.18 m2/g) and the highest metal oxide dispersion (5.65%). These results are relevant to the flow behavior of catalyst slurry which plays a key role in coating the catalyst gel on the polymer template. The thermal decomposition rate used to remove the polymer template from the catalyst structure is proportional to the ceramic foam structure (catalyst support structure). The slow decomposition rate bent and fractured foam-cell struts more than the faster rate. On the other hand, achieving good catalyst dispersion on catalyst supports necessitated a high sintering rate. When sintering was adjusted at a high sintering rate, the metal-particle dispersion was relatively high, around 7.44%, and the surface area of ceramic foam catalysts was 64.61 m2/g. Finally, the catalytic behavior toward hydrogen production through the dry reforming of methane using a fixed-bed reactor was evaluated under certain operating conditions.

Reticulated Replica Ceramic Foams: Processing, Functionalization, and Characterization

Microstructure of ceramic foams

Factors affecting the microstructure of a fine ceramic foam

60 years open‐celled ceramics based on replica technique – Applications, obstacles and opportunities

Preparation of Large Effective Specific Surface Area Reticulate Porous Ceramics by Polymeric Foam Replication Process Using Recoating Technique

Increased Microporosity in Ceramic and Metal Foams: A Novel Processing Combination

Tailoring of the Wetting Behavior of Alumina Dispersions on Polymer Foams by Methylcellulose Addition: A Route Toward Mechanically Stable Ceramic Replica Foams

Fabrication of a Ceramic Foam Catalyst Using Polymer Foam Scrap via the Replica Technique for Dry Reforming

3D Printable Ultra‐Highly Porous and Mechanically Strong Foam Materials for Multiple Applications

Processing Routes to Macroporous Ceramics: A Review

A Review on Recent Development of Foam Ceramics Prepared by Particle-Stabilized Foaming Technique

Preparation and characterization of ceramic foams mainly containing extracted titanium residues and silica tailings

Processing Methods for the Preparation of Porous Ceramics

Preparation of γ-Al2O3/α-Al2O3 ceramic foams as catalyst carriers via the replica technique

Mechanically Robust ZrO2 Foams with 3D Reticular Architecture Prepared from Chemical‐modified ZrO2 Powder

Ceramic foams with highly open channel structure from direct foaming method in combination with hollow spheres as pore-former.

Preparation Of Ceramic Foam Filters Via Direct Foaming

Fabrication of Porous Ceramics by Direct Foaming

Highly Porous and Mechanically Robust Al2O3-based Foams with Self-Wrinkled and Rough Aperture Surfaces Via Binary Colloidal Self-Assembly of Nanoparticle/gelation Network

Recent Progress in Processing Functionally Graded Polymer Foams