Abstract:Ultra‐highly porous and mechanically strong materials are made by tuning interfacial chemistry of the nanoparticle suspensions. The introduced ethanol assists the surfactant to be adsorbed onto the silica surface with enhanced efficiency. High energy of attachment of the nanoparticles improves the stability of the Pickering system. The strong interactions within the foam endow the green bodies with mechanical strengths as well. Highly porous foam ceramics exhibit broad prospects for multifunctional applications. With the facile Pickering‐based foaming technique, wet foams consisting of nanoparticles (NPs) may exhibit high strengths. However, they also experience linear shrinkages as high as 50% after drying and sintering process. Suitable solutions for improving this situation have not been found yet. This work develops a method for fabricating NP‐made foam ceramics by tuning the interfacial chemistry of this Pickering system. Trace amounts of ethanol are used to adjust the adsorbing behavior of surfactants on the silica surface to enhance the energy of attachment of the Pickering systems. Combined with the altered capillary forces, the linear shrinkages of the foam ceramic are considerably lowered. The pore wall of the obtained foam ceramics can be tuned to either closed or open due to the "coffee ring" effect by adjusting the solid content and sintering temperature. The samples present high thermal insulating properties and high mechanical strength even the unsintered ones, which also show good stability in liquid environments. Combined with the direct ink writing (DIW) technique, these freely shaped materials with tunable pore structures can be readily exploited in tissue scaffolds, catalyst carriers, thermal insulators, battery electrodes, and liquid/gas filtration, etc.

A Review on Recent Development of Foam Ceramics Prepared by Particle-Stabilized Foaming Technique

Microstructure of Ceramic Foams

Factors affecting the microstructure of a fine ceramic foam

Fabrication of Porous Ceramics by Direct Foaming

Porous Ceramic from Particle-Stabilised Foams Via Gelcasting

3D Printable Ultra‐Highly Porous and Mechanically Strong Foam Materials for Multiple Applications

Preparation and Applications of Foam Ceramics

Improvement of Microstructural Controllability of Cellular Ceramic for Multifunctional Composites

Recent advances in nanomaterial-stabilized pickering foam: Mechanism, classification, properties, and applications

Highly Porous and Hierarchical MgAl2O4 Ceramics with Improved Pore Connectivity Prepared from Gelled Particle-Stabilized Foams

Foam structure-derived strong and tough alumina ceramics with fine grains and transgranular fracture

Fabrication of foamed ceramics with enhanced compressive strength and low thermal conductivity via a simple route

Study of Affecting Factors on Porosity in Gel-Casting Foam

Pore Structure Control of Si3n4 Ceramics Based on Particle-Stabilized Foams

Ceramic foams with highly open channel structure from direct foaming method in combination with hollow spheres as pore-former.

A Novel Process to High‐strength and Controlled‐shrinkage Al2O3 Foams with Open‐cell by Al Powder Hollowing Technology

Hierarchically Porous Ceria with Tunable Pore Structure from Particle-Stabilized Foams

Preparation Of Ceramic Foam Filters Via Direct Foaming

A Review of the Preparation of Porous Fibers and Porous Parts by a Novel Micro-Extrusion Foaming Technique

PARTICLE-STABILIZED FOAMS SLURRY AND MANUFACTURING OF POROUS ALUMINA CERAMICS