Abstract:Ultra‐highly porous and mechanically strong materials are made by tuning interfacial chemistry of the nanoparticle suspensions. The introduced ethanol assists the surfactant to be adsorbed onto the silica surface with enhanced efficiency. High energy of attachment of the nanoparticles improves the stability of the Pickering system. The strong interactions within the foam endow the green bodies with mechanical strengths as well. Highly porous foam ceramics exhibit broad prospects for multifunctional applications. With the facile Pickering‐based foaming technique, wet foams consisting of nanoparticles (NPs) may exhibit high strengths. However, they also experience linear shrinkages as high as 50% after drying and sintering process. Suitable solutions for improving this situation have not been found yet. This work develops a method for fabricating NP‐made foam ceramics by tuning the interfacial chemistry of this Pickering system. Trace amounts of ethanol are used to adjust the adsorbing behavior of surfactants on the silica surface to enhance the energy of attachment of the Pickering systems. Combined with the altered capillary forces, the linear shrinkages of the foam ceramic are considerably lowered. The pore wall of the obtained foam ceramics can be tuned to either closed or open due to the "coffee ring" effect by adjusting the solid content and sintering temperature. The samples present high thermal insulating properties and high mechanical strength even the unsintered ones, which also show good stability in liquid environments. Combined with the direct ink writing (DIW) technique, these freely shaped materials with tunable pore structures can be readily exploited in tissue scaffolds, catalyst carriers, thermal insulators, battery electrodes, and liquid/gas filtration, etc.

Mechanically Robust ZrO2 Foams with 3D Reticular Architecture Prepared from Chemical‐modified ZrO2 Powder

High-Strength and Shape-Memory Epoxy Cellular Material with Wood-Like Architecture

Highly Porous ZrO2 Cellular Ceramics with 3D Network Architecture

Factors affecting the microstructure of a fine ceramic foam

Microstructure of Ceramic Foams

Ceramic foams with highly open channel structure from direct foaming method in combination with hollow spheres as pore-former.

Hierarchically Porous Ceria with Tunable Pore Structure from Particle-Stabilized Foams

3D Printable Ultra‐Highly Porous and Mechanically Strong Foam Materials for Multiple Applications

Ultralight and Mechanically Robust SiC Foams with Interconnected Cellular Architecture

Highly Porous and Mechanically Robust Al2O3-based Foams with Self-Wrinkled and Rough Aperture Surfaces Via Binary Colloidal Self-Assembly of Nanoparticle/gelation Network

Ultra-high Strength ZTA Ceramic Foams with Large Amounts of Intragranular Structures Resulting from Dual-Phase Sol

Ultralight and High-Strength Bulk Alumina/zirconia Composite Ceramic Foams Through Direct Foaming Method

3D printing boehmite gel foams into lightweight porous ceramics with hierarchical pore structure

Preparation and stereolithography 3D printing of ultralight and ultrastrong ZrOC porous ceramics

Highly Porous and Hierarchical MgAl2O4 Ceramics with Improved Pore Connectivity Prepared from Gelled Particle-Stabilized Foams

High-strength, 3D interconnected alumina ceramic foams with high porosity comparable to aerogels

Mechanical strength of highly porous ceramic foams with thin and lamellate cell wall from particle-stabilized foams

Camphene-based Freeze-Cast ZrO2 Foam with High Compressive Strength

Highly Porous Alumina Cellular Ceramics Bonded by In-Situ Formed Mullite Prepared by Gelation-Assisted Al2O3–Si Particle-Stabilized Foams

Hierarchical cellular scaffolds fabricated via direct foam writing using gelled colloidal particle‐stabilized foams as the ink