Abstract:Controlling the preparation process is essential to ensure the quality of the ceramics. Previous research on the ceramic process concentrated on a certain part of powder synthesis, forming, or sintering. Herein, we propose a novel process, foam precursor-derived Al2O3 ceramics, to realize particle rearrangement, assembly, and sintering and find that this method has a marvelous influence on the microstructure and mechanical properties. Alumina foams prepared by the particle-stabilized foam method are used as ceramic precursors, and after pre-sintering, crash, and hot pressing, foam precursor-derived Al2O3 ceramics can be obtained. It has fine grains (1/5 of the traditional process) and uniform grain size without any additional sintering aid, realized by the high grain growth exponent of foams. Ultrahigh dislocation density (similar to 1010 mm-2) is discovered in (0 0 0 1) plane of foam precursor-derived ceramics, comparable to the dislocation density of high-entropy ceramics. Besides, transgranular fracture mode is observed in the ceramics prepared by the new method rather than the intergranular fracture in the control group, and the comprehensive mechanical properties are promoted accordingly. The unusual microstructure and fracture mode caused by the foam precursor process reveal the influence of the microstructure such as dislocation and grain boundary on the fracture behavior of ceramics, which is less considered in conventional research. This preparation process may be applied in the preparation of other high-performance ceramics.

Ultralight and High-Strength Bulk Alumina/zirconia Composite Ceramic Foams Through Direct Foaming Method

Factors affecting the microstructure of a fine ceramic foam

Ultrahigh‐strength Alumina Ceramic Foams Via Gelation of Foamed Boehmite Sol

Ultra-high Strength ZTA Ceramic Foams with Large Amounts of Intragranular Structures Resulting from Dual-Phase Sol

Mechanical strength of highly porous ceramic foams with thin and lamellate cell wall from particle-stabilized foams

Cost-effective Fabrication of Bio-Inspired Nacre-Like Composite Materials with High Strength and Toughness

Highly Porous Zirconia Ceramic Foams with Low Thermal Conductivity from Particle‐Stabilized Foams

Highly Porous Alumina Cellular Ceramics Bonded by In-Situ Formed Mullite Prepared by Gelation-Assisted Al2O3–Si Particle-Stabilized Foams

High-strength, 3D interconnected alumina ceramic foams with high porosity comparable to aerogels

Facile method for preparing lamellar structured alumina-zirconia ceramics with high toughness

Ceramic foams with highly open channel structure from direct foaming method in combination with hollow spheres as pore-former.

High-strength porous alumina ceramics prepared from stable wet foams

Strong and Tough Alumina Ceramic from the Particle‐Stabilized Foam

Ultralight Alumina Ceramic Foams with Single-Grain Wall Using Sodium Dodecyl Sulfate As Long-Chain Surfactant

A Novel Process to High‐strength and Controlled‐shrinkage Al2O3 Foams with Open‐cell by Al Powder Hollowing Technology

Highly Porous and Hierarchical MgAl2O4 Ceramics with Improved Pore Connectivity Prepared from Gelled Particle-Stabilized Foams

Foam structure-derived strong and tough alumina ceramics with fine grains and transgranular fracture

Ultra-high Porosity of Open-Cell Alumina Ceramic Foams Prepared by Adding Tiny Amounts of Γ-Alo(oh) Sol

Strength Enhancement of Ultralight Alumina‐dried Foams from Particle‐stabilized Foams with Assistance of Agar and PVA

Ultrahigh-Strength Porous Ceramic Composites via a Simple Directional Solidification Process

The microstructural characterization and mechanical response of YSZ ceramic foams fabricated via volume-controlled foaming