Abstract:The design of super thermal insulation and high-temperature resistant materials for high temperature furnaces is crucial due to the energy crisis and the huge wasting. Although it is told that numerous studies have been reported about various of thermal insulation materials prepared by different methods, the applications of yttria-stabilized zirconia (YSZ) ceramic foams fabricated through tert-butyl alcohol (TBA)-based gel-casting process in bulk thermal isolators were barely to seen. In this paper, highly porous yttria-stabilized zirconia (YSZ) ceramic foams were fabricated by a novel gel-casting method using tert-butyl alcohol (TBA) as solvent and pore-forming agent. Different raw material ratio, sintering temperature and soaking time were all investigated to achieve optimal thermal insulation and mechanical properties. We can conclude that porosity drops gradually while compressive strength increases significantly with the rising temperature from 1000-1500°C. With prolonged soaking time, there is no obvious change in porosity but compressive strength increases gradually. All specimens have uniformly distributed pores with average size of 0.5-2μm and show good structural stability at high temperature. The final obtained ceramic foams displayed an outstanding ultra-low thermal conductivity property with only 200.6 °C in cold surface while the hot side was 1000 °C (hold 60 min to keep thermal balance before testing) at the thickness of 10 mm.

Highly Porous Zirconia Ceramic Foams with Low Thermal Conductivity from Particle‐Stabilized Foams

Porous yttria-stabilized zirconia ceramics with low thermal conductivity via a novel foam-gelcasting method

Hierarchically porous lanthanum zirconate foams with low thermal conductivity from particle‐stabilized foams

A novel highly porous ceramic foam with efficient thermal insulation and high temperature resistance properties fabricated by gel-casting process

Ultralight and High-Strength Bulk Alumina/zirconia Composite Ceramic Foams Through Direct Foaming Method

Ultra-high Strength ZTA Ceramic Foams with Large Amounts of Intragranular Structures Resulting from Dual-Phase Sol

Pyrochlore-fluorite dual-phase high-entropy ceramic foams with extremely low thermal conductivity from particle-stabilized suspension

Porous yttria-stabilized zirconia ceramics with ultra-low thermal conductivity

Mechanical strength of highly porous ceramic foams with thin and lamellate cell wall from particle-stabilized foams

Highly porous YSZ ceramic foams using hollow spheres with holes in their shell for high-performance thermal insulation

Ceramic foams with highly open channel structure from direct foaming method in combination with hollow spheres as pore-former.

Ultralight Alumina Ceramic Foams with Single-Grain Wall Using Sodium Dodecyl Sulfate As Long-Chain Surfactant

Mullite Ceramic Foams with Tunable Pores from Dual-Phase Sol Nanoparticle-Stabilized Foams

The microstructural characterization and mechanical response of YSZ ceramic foams fabricated via volume-controlled foaming

Fabrication of foamed ceramics with enhanced compressive strength and low thermal conductivity via a simple route

Facile Method for Preparing Hierarchical Al2O3-Glass Foam Ceramics with Superior Thermal Insulating Property.

Microstructure and properties of highly porous Y2SiO5 ceramics produced by a new water-based freeze casting

Aerogel‐like Ceramic Foams with Super‐high Porosity and Nanoscale Cell Wall from Sol Nanoparticles Stabilized Foams

Ultra-high Porosity of Open-Cell Alumina Ceramic Foams Prepared by Adding Tiny Amounts of Γ-Alo(oh) Sol

Low sintering shrinkage and high strength of porous mullite–zirconia ceramics: Effect of AlF3 and ZrSi2 contents

Facile Method for Preparing Hierarchical Al 2 O 3 –Glass Foam Ceramics with Superior Thermal Insulating Property