Abstract:Understanding the mechanical properties of polymer nanocomposite materials is essential for industrial use. Particularly, the determination of the polymer modulus at the nanofiller-polymer interphase is important for optimizing the interfacial mechanical properties. Nanoindentation via Atomic Force Microscopy (AFM) is well established for measuring the modulus of the interphase region with nanoscale spatial resolution. However, indentation into heterogeneous materials presents a confounding issue often referred to as the "substrate effect", i.e., the structural stress field caused by the rigid body is convoluted with the actual modulus of the interphase region. While finite element analysis (FEA)-based methods can be used to deconvolute the interphase modulus from measured apparent modulus-distance profiles, the experimental validation of this method is still needed. Here, we provide this validation using AFM nanoindentation on a layered model composite which consists of three layers with different moduli to recapitulate the properties of the matrix, the filler, and the interphase of real polymer nanocomposites. By systematically varying the thickness of the “artificial” interphase layer and the AFM probe radius, we obtain modulus - distance profiles over a wide range of indentation conditions. We validate a method to deconvolute the substrate effect using an empirically derived master curve obtained from FEA analysis. Furthermore, we showed that the effect of the artificial interphase on modulus - distance profiles can be distinguished only if the interphase layer is thick enough compared to the contact radius of the probe. Finally, we established an innovative and quantitative framework to predict the interphase thickness from mechanical nanoindentation measurements, and we discussed the lower, practical limit for interphase thickness determination. In summary, we provide a broadly applicable method to extract interphase mechanical properties of multiphase soft materials, and practical guidelines for choosing optimal characterization conditions.

Material discrimination and mixture ratio estimation in nanocomposites via harmonic atomic force microscopy

Influence of Material Surface on the Measurement of Local Electrical Conductivity Using Microwave Atomic Force Microscopy

J0610104 Evaluation of Interatomic Force on the Tip of Probe by Using Microwave Atomic Force Microscope

Cantilever Optimization for Applications in Enhanced Harmonic Atomic Force Microscopy

Study of the Raman-Afm System for Simultaneous Measurements of Raman Spectrum and Micro/Nano-Structures

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Interface Probing by Dielectric Frequency Dispersion in Carbon Nanocomposites

OS1508 Investigation of Interatomic Force under the Tip of Microwave-AFM Probe

Light-modulated van der Waals force microscopy

Measuring the Interfacial Thickness of Immiscible Polymer Blends by Nano-probing of Atomic Force Microscopy

High Power Ultrasonic Testing Method for Agglomeration of Nanoparticles in Nanocomposite Dielectrics

Multiparametric characterization of heterogeneous soft materials using contact point detection-based atomic force microscopy

Heterodyne High-Harmonic Electrostatic Force Microscopy with Improved Spatial Resolution for Nanoscale Identification of Metallic/Semiconducting Carbon Nanotubes

Quantification of surface displacements and electromechanical phenomena via dynamic atomic force microscopy

Re-evaluation of the Widely Applied Force-Frequency Relation for Frequency-Modulation AFM under Solution

Interfacial interaction and enhanced image contrasts in higher mode and bimodal mode atomic force microscopy

High-spatial-resolution composition analysis of micro/nano-structures with a nanoscale compositional variation

Visualization of Nanomechanical Mapping on Polymer Nanocomposites by AFM Force Measurement

Analysis Of Factors In The Nanoscale Physical And Electrical Characterization Of High-K Materials By Conductive Atomic Force Microscope

Pushing AFM to the boundaries — interphase mechanical property measurements near a rigid body

Simultaneously Measuring Force and Displacement: Calibration of Magnetic Torque Actuated Microcantilevers for Nanomechanical Mapping