Abstract:Magnesium oxide (MgO) thin films with different magnesium concentrations ([Mg2+] = 0.05, 0.1, 0.15 and 0.2 mol·L−1) in a spray solution have been successfully grown using a spray pyrolysis technique. X-ray diffraction (XRD), Maud software, FTIR spectroscopy, a confocal microscope, Wien2k software, spectrophotometry and a Photoluminescence spectrometer were used to investigate the structural, morphological and optical properties. XRD analysis revealed a better crystalline quality of the MgO thin layer synthesized with [Mg2+] = 0.15 mol·L−1, which crystallized into a face-centered cubic structure along the preferred orientation (200) lattice plan. The enhancement of the crystalline quality for the MgO thin film ([Mg2+] = 0.15 mol·L−1) was obtained, which was accompanied by an increment of 94.3 nm of the crystallite size. No secondary phase was detected and the purity phase of the MgO thin film was confirmed using Maud software. From the transmission spectra results, high transparent and antireflective properties of the MgO thin film were observed, with an average transmission value of about 91.48% in the visible range, which can be used as an optical window or buffer layer in solar cell applications. The films also have a high reflectance value in the IR range, which indicates that the highly reflective surface will prevent an increase in surface temperature under solar irradiation, which could be beneficial in solar cell applications. A direct band gap type was estimated using the Tauc relation which is close to the experimental value of 4.0 eV for optimal growth. The MgO material was tested for the degradation of methylene blue (MB), which reached a high photodegradation rate of about 83% after 180 min under sunlight illumination. These experimental trends open a new door for promising the removal of water contaminants for photocatalysis application.

Facile and rapid synthesis of nanoplates Mg(OH)2 and MgO via Microwave technique from metal source: structural, optical and dielectric properties

Simple Synthesis of Single-crystalline Nanoplates of Magnesium Oxide

Preparation and Characterization of Mg-doped ZnO Thin Films by Sol–gel Method

Synthesis And Characterization Of Porous Magnesium Hydroxide And Oxide Nanoplates

Microwave-assisted synthesis of fibre-like Mg(OH)2 nanoparticles in aqueous solution at room temperature

Preparation and characterization of lamellar-like Mg(OH)2 nanostructures via natural oxidation of Mg metal in formamide/water mixture

Nanoscale magnesium hydroxide and magnesium oxide powders: Control over size, shape, and structure via hydrothermal synthesis

Influence of Mg doping on the microstructure and PL emission of wurtzite ZnO synthesized by microwave processing

Synthesis of Mg(Oh)(2) Nanoparticles from Mgo Using Magnesium Acetate As Additive

Mg(OH)2 nanoparticles produced at room temperature by an innovative, facile, and scalable synthesis route

MgO nanostructures synthesized by thermal evaporation

Magnesium Nitrate As Additive for Synthesis of Mg(OH)2 Nanoparticles

Synthesis and Characterization of MgO Thin Films Obtained by Spray Technique for Optoelectronic Applications

Synthesis of MgO Microspheres with Nanosheets in a Mechanical Force Reactor and Its Optical Property

The Preparation of Magnesium from Magnesia by Using Atmospheric Microwave Al-C Reduction Method

(NaPO3)6-assisted wet formation of dispersive Mg(OH)2 nanoplates

A simple solution calcination route to porous MgO nanoplates

Highly Textural Lamellar Mesostructured Magnesium Hydroxide Via A Cathodic Electrodeposition Process

Structural Characteristics and Flame-Retardant Properties of Nanosized Magnesium Hydroxide

Additives Applied for Preparation of Superfine Mg(Oh)(2) Particles by Light-Burned Mgo at Low Temperature

Hydrogen Production Via Hydrolysis of Mg-oxide Composites