Abstract:Abstract Reciprocating compressor is one of the key machines in chemical and petrochemical industries. The most common failure mode in the compressor is valve leakage. Generally, leakage fault is considered to be of little harm to machines. However, it was found that the serious leakage of the valve would cause abnormal bending vibration of the piston rod and accelerate the formation of fatigue cracks. Most researchers utilized the signal of cylinder dynamic pressure, valve temperature or acoustic emission to diagnose valve leakage fault. However, each of these methods has disadvantages. In this paper, a new method is proposed to diagnose valve leakage fault using vibration signal. The main idea is that the severity of valve leakage can be assessed by analyzing energy of the main frequency band during compression process and the delay of discharge valve opening. Firstly, the vibration signal in the time domain is segmented into several angle-domain signals according to the keyphasor signal. Each of the angle-domain signals corresponds to one cylinder working cycle. Then, the time-frequency analysis is conducted with the Gaussian window, and the main energy frequency band and the compression process are determined. Filtering the signal with a bandpass filter based on the main energy frequency band, and the root-mean-square (RMS) of the filtered signal during compression process is calculated in a crank revolution. Besides, the angle of discharge valve opening is detected. Based on the two indicators, the severity of valve leakage can be estimated. To verify the effectiveness of the method, keyphasor of the flywheel, cylinder dynamic pressure and vibration acceleration of valve are acquired on a double-acting oil-free air compressor under different degrees of suction valve leakage. The experimental results and analysis show that the proposed method can well identify the valve leakage fault, even in the case of weak leakage, and is very effective in quantifying the severity of leakage.

Quantification of Valve Severity in Reciprocating Compressor by Using Acoustic Emission Technique

Detection and estimation of valve leakage losses in reciprocating compressor using acoustic emission technique

Assessment of characteristics of acoustic emission parameters for valve damage detection under varying compressor speeds

Experimental investigation of the fault diagnosis of typical faults in reciprocating compressor valves

Research on the Diagnosis Method of Reciprocating Compressor Valve Leakage Fault With Vibration Signal

Valve Dynamic Characteristic and Stress Analysis of Reciprocating Compressor Under Stepless Capacity Regulation

A Comparative Experimental Study on the Use of Machine Learning Approaches for Automated Valve Monitoring Based on Acoustic Emission Parameters

Valve Plate Roll Analysis on Stepless Capacity Regulation for Reciprocating Compressor

Valve Dynamic and Thermal Cycle Model in Stepless Capacity Regulation for Reciprocating Compressor

Investigation on recognition method of acoustic emission signal of the compressor valve based on the deep learning method

Reciprocating Compressor Fault Diagnosis Based on Airborne Acoustic Signal: Comparison Study Between Modulation Signal Bi-spectrum and Teager Energy Spectrum Method

Condition monitoring of hydraulic cylinder seals using acoustic emissions

Numerical and experimental investigation of cavitation characteristics of the electronic expansion valves

Acoustic Emission Valve Disc Slight Opening Recognition Technology

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Cavitation and Acoustic Analysis of Sleeve Steam Trap under Multiple Working Conditions

Rotational Machine Health Monitoring and Fault Detection Using Emd-Based Acoustic Emission Feature Quantification

An Operating Condition Information-Guided Iterative Variational Mode Decomposition Method Based on Mahalanobis Distance Criterion for Surge Characteristic Frequency Extraction of the Centrifugal Compressor

Fault Diagnosis Method Based on AUPLMD and RTSMWPE for a Reciprocating Compressor Valve

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Gas Face Seal Status Estimation Based on Acoustic Emission Monitoring and Support Vector Machine Regression