Abstract:The pre-peak microstructure evolution of the material is crucial in determining the strength and failure scheme of the material, but is not captured by the existing shear strength parameters models which focus on post-peak stage information. Novel concepts of pseudo-cohesion and pseudo-internal friction angle that account for both the pre-peak and post-peak stage information were proposed in this study, based on the experimentally observed response of the rock mechanics parameters to an external load (the maximum principal stress). These two parameters were analytically derived as functions of maximum principal strain, with coefficients to be determined (i.e., by applying the Mohr–Coulomb criterion with these parameters to experimental data). The dependence of pseudo-cohesion and pseudo-internal friction angle on the axial strain and confining pressure was investigated. The evolution of the strength parameters was found to relate to the propagation of micro-crack developed in the loading process, as revealed by PFC 2D simulations reproducing experiments. The results show that (1) analytical model characterizing the pseudo-cohesion and internal friction angle as the quadratic function of axial strain accurately reflects the mechanical response characteristics of the specimen; (2) before the residual stage, the pseudo-cohesion first increases and then decreases with increasing strain, while the pseudo-internal friction angle increases continuously; (3) for the sandstone specimens studied, the pseudo-cohesion at the peak stress increases by a gradually decreasing rate with increasing confining pressure, while the pseudo-internal friction angle at the peak stress decreases by a decreasing rate with the increasing confining pressure; (4) CPM well characterized the mechanical properties of rock under multiple confining pressures, as the total stress–strain curves and failure modes of numerical specimens reproduced the experimental results. The evolution of rock pseudo-shear strength parameters is closely related to the external load and the generation, propagation, and penetration process of rock cracks. The rock pseudo-shear strength parameters are gradually mobilized with the increasing load, and the propagating of cracks owing to the decrease of mobilizable maximum cohesion and the increase of mobilizable maximum internal friction angle.

Shear-band of sand simulated by Particle Flow Code (PFC)

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Multiscale Modeling and Analysis of Compaction Bands in High-Porosity Sandstones

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Shear Wave Velocity in Sand Considering the Effects of Frequency Based on Particle Contact Theory

PARAMETER SENSITIVITY ANALYSIS OF DIRECT SHEAR TEST BY PARTICLE FLOW CODE SIMULATION

Three-dimensional Discrete Element Simulation of the Triaxial Cyclic Loading of Sandstone Based on a Nonlinear Parallel-Bonded Stress Corrosion Model

Shear Band Between Steel and Carbonate Sand Under Monotonic and Cyclic Loading

Experimental Study on Mesoscopic Shear Behavior of Calcareous Sand Material with Digital Imaging Approach

Micromechanics-based multimechanism bounding surface model for sands

Formula for inclination angle of shear band based on soil state and microscopic characteristics in sands

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

EXPERIMENT AND DISCRETE ELEMENT NUMERICAL SIMULATION FOR INFLUENCE OF PARTICLE MORPHOLOGY ON SHEAR STRENGTH OF SAND

Study on Meso-Mechanical Behavior of Sand Based on Its 2D Geometrical Model

A novel obtaining method and mesoscopic mechanism of pseudo-shear strength parameter evolution of sandstone

Theoretical and experimental study on multiscale coupled Mohr–Coulomb shear strength criterion of fibre-reinforced sand

Coupled effects of particle overall regularity and sliding friction on the shear behavior of uniformly graded dense sands

Study on shear characteristics of calcareous sand with different particle size distribution

Micromechanism study on the influence of particle deposition angle on mechanical properties of sand

Shear Strength Behaviors of Aeolian Sand Solidified by Microbially Induced Calcite Precipitation and Basalt Fiber Reinforcement