Abstract:Electron energy loss spectroscopy (EELS) has been widely used in analysis of ceramic, minerals and semiconductors. It can provide the unique advantage of sensitivity to composition, coordination and valency, while providing nano-scale spatial resolution. Due to the electron irradiation sensitivity, EELS studies on glass are quite rare. However, using special care in glass-composition selection and by recording time series of EELS-spectra to monitor any structural changes, EELS then becomes a very useful technique to study glass-chemistry and glass structure with the highest spatial resolution of all chemically sensitive techniques. Alkali borosilicate glasses (ABS) doped with Cr2O3 (2 mol%), CeO2 (4 mol%) and ZrO4 (4 mol%) were melted, cooled and annealed in the context of simulating radionuclide immobilisation glasses. Precipitates with diameter in the range of ∼20 nm to ∼200 nm were found homogeneously distributed in the glass. In preliminary studies we measured the oxidation state in the glass and in precipitates via evaluation of the Ce-M-edge double white line ratio, confirming the crystals as Ce(IV) oxide. We also found Boron K-edge ELNES spectra as a sensitive signal to boron coordination (N4 = BO4/(BO3+BO4)), which is found at N4 ratios of around 35-45%. In the present study we have extended this work to the acquisition of dense line scans (spectrum imaging) across an area of interest on our composite glass with emphasis on three questions: (i)Change of cerium valence upon transition from the glass to the precipitates? (ii)Possible oscillation of boron N4-ratio in the glass within a line scan as a consequence of random medium-order related glass fluctations when scanning the <5nm probe across a seemingly homogeneous area? (iii)N4-changes in the immediate glass layer surrounding the precipitates? Our ongoing research has produced results which prove a systematic change of the Ce oxidation state from precipitates (+IV) to glass (mixed +III/+IV). It is found that boron coordination is constant within the sensitivity given by signal-to-noise in the glass matrix. A change of the Boron K-edge fine structure upon crossing a nanoparticle during one particular linescan has been observed, which could hint to a coordination change of the glass layer surrounding the particle. Other linescan measurements have not shown any change and acquisition of an enlarged better statistic is work in progress. The ABS-glass with distributed nanoparticles provides an ideal example of a 3D nanocomposite. The only proven technique for the three-dimensional reconstruction of such materials on the nanoscale is electron tomography. We present the first results of a 3D reconstructed nuclear waste glass by using a tilt series of ADF STEM images covering a glass fragment of 2000nm field of view containing several tens of nanoparticles distributed around its volume.

Development and optimization of a simple internal beam current monitoring approach using 29Si(p,p′γ)29Si reaction in particle induced gamma-ray emission for compositional characterization of glass samples and application to automobile windshield glasses

Simultaneous quantification of low Z elements in phosphorus containing alkali borosilicate glass samples by in situ Current normalized external (in air) PIGE method utilizing proton beam from FOTIA

Optimization of external (in air) particle induced gamma-ray emission (PIGE) methodology for rapid, non-destructive, and simultaneous quantification of fluorine, sodium, and phosphorus in nuclear waste immobilization matrices

Positron Annihilation Lifetime Spectroscopy (PALS) Studies of Gamma Irradiated As 2 Se 3 Films Used in MIR Integrated Photonics

Nanostructured Glass Composite for Self‐Calibrated Radiation Dose Rate Detection

Detection of interstitial oxygen contents in Czochralski grown silicon crystals using internal calibration in laser-induced breakdown spectroscopy (LIBS)

Development of an innovative external (in air) Particle Induced Gamma-ray Emission method for rapid non-destructive determination of isotopic composition of boron in "As received" boron based ceramic neutron absorbers

Near infrared spectroscopy for on-line monitoring during the manufacture of alkali-free glass cloth

Optimisation and Characterisation of Glass RPC for India-based Neutrino Observatory Detectors

X-ray microanalysis in STEM of short-term physico-chemical reactions at bioactive glass particles / biological fluids interface. Determination of O/Si atomic ratios

Quantitative Imaging Analysis and Investigation of Transmission Loss in PbF2 Crystals by Laser Ablation-Inductively Coupled Plasma-Mass Spectrometry Method.

X-Ray Emission Measurement from Organic and Insulating Materials with Low Energy Ga Ion Beams

Glass cutting optimization with pump-probe microscopy and Bessel beam profiles

Ion beam induced luminescence (IBIL) analysis of europium-activated phosphate glass micro-beads scintillators at clinical carbon beam therapy field

EELS Spectrum Imaging and Tomography Studies of Simulated Nuclear Waste Glasses

Combined use of multiple external and internal standards in LA-ICP-MS analysis of bulk geological samples using lithium borate fused glass

On-line monitoring of sealing glass in electrical penetration assembly based on femto-laser inscribed fiber Bragg grating sensors.

Exploring Gamma Radiation Shielding: the Role of BaO in Borosilicate Glasses

Improvement of Electron Probe Microanalysis of Boron Concentration in Silicate Glasses

Investigation of the Gamma Irradiation-Induced Structural, Optical, Luminescence and Shielding Properties of CuO-Integrated Sodium-Zinc-Borate Glasses

A New Methodology for Radiation Effects Studies in Solids using the Plasma Focused Ion Beam